In the present study, an ultra-high performance liquid chromatography coupled with quadrupole time-of-flight mass spectrometry (UHPLC-QTOF-MS) method for simultaneous determination of eleven original, fourteen degraded ginsenosides and five aglycones was developed and validated to quantitatively evaluate the transformation of ginsenosides during preparation of Du-Shen-Tang, the decoction of ginseng. Both positive and negative modes as well as the step wave ion transfer optics technology were used to increase the detection sensitivity of QTOF-MS. The extracting ion mode based on the quasi-molecular ions, molecular ions and fragment ions characteristic to each analyte was used to increase the selectivity for quantitative analysis. Under the optimized UHPLC and QTOF-MS conditions, the 30 analytes with different polarities were separated (except for Re and Rg₁) within 26 min. The developed method was applied for the quantitative comparison of Du-Shen-Tang and its raw materials derived from Asian ginseng (ASG) and American ginseng (AMG), respectively. It was found that the contents of the original ginsenosides decreased from 26,053.09 to 19,393.29 μg/g or 45,027.72 to 41,865.39 μg/g, whereas the degraded ginsenosides and aglycones increased from 159.72 to 685.37 μg/g or 676.54 to 1,502.26 μg/g in Du-Shen-Tang samples of ASG or AMG when compared with their raw materials, indicating that decocting could dramatically increase the proportion of the less polar degraded ginsenosides in Du-Shen-Tang. Whether these changed proportions of different polar ginsenosides could affect the bioactivities of the decoctions and their raw materials derived from ASG and AMG deserves further investigation.

Cicadae Periostracum (CP) is a traditional Chinese medicinal herb derived from the slough that is molted from the nymph of the insect Cryptotympana pustulata Fabricius. Washing with water to remove residual silt is a primary processing method of CP that is recommended by the Chinese Pharmacopoeia, but how washing methods affect the quality and bioactivity of CP is unknown. In this study, the quality and bioactivity of non-washed CP (CP-NW), post-molting-washed CP (CP-WAT), and pre-molting-washed CP (CP-WBT) were comparatively investigated. The quality of these CP samples was evaluated in terms of the UPLC-QTOF-MS/MS-based chemical profiling and semi-quantification of 39 N-acetyldopamine oligomers (belonging to six chemical types), the HPLC-UV-based quantification of 17 amino acids, the ICP-MS-based quantification of four heavy metals, and the contents of ash; the bioactivities of the samples were compared regarding their anti-oxidant and anti-inflammatory activities. It was found that, compared with CP-NW, both CP-WBT and CP-WAT had significantly lower contents of ash and heavy metals. Moreover, compared with CP-WAT, CP-WBT contained lower levels of total ash, acid-insoluble ash, and heavy metals and higher contents of N-acetyldopamine oligomers and amino acids. It also had enhanced anti-oxidant and anti-inflammatory activities. A Spearman’s correlation analysis found that the contents of N-acetyldopamine oligomers and free amino acids were positively correlated with the anti-oxidant/-inflammatory activities of CP. All these results suggest that pre-molting washing can not only remove the residual silt but can also avoid the loss of the bioactive components and assure higher bioactivities. It is concluded that pre-molting washing could enhance the quality and bioactivity of CP and should be a superior alternative method for the primary processing of qualified CP.