Recently, as a supplement of cement, the utilization of pozzolanic materials in cement and concrete manufacturing has increased significantly. This study investigates the scope to use pozzolanic wastes (slag, palm oil fuel ash and rice husk ash) as an alkali activated binder (AAB) that can be used as an alternative to cement. To activate these materials, sodium hydroxide solution was used at 1.0, 2.5 and 5.0 molar concentration added into the mortar, separately. The required solution was used to maintain the flow of mortar at 110% ± 5%. The consistency and setting time of the AAB-paste were determined. Mortar was tested for its flow, compressive strength, porosity, water absorption and thermal resistance (heating at 700 °C) and investigated by scanning electron microscopy. The experimental results reveal that AAB-mortar exhibits less flow than that of ordinary Portland cement (OPC). Surprisingly, AAB-mortars (with 2.5 molar solution) achieved a compressive strength of 34.3 MPa at 28 days, while OPC shows that of 43.9 MPa under the same conditions. Although water absorption and porosity of the AAB-mortar are slightly high, it shows excellent thermal resistance compared to OPC. Therefore, based on the test results, it can be concluded that in the presence of a chemical activator, the aforementioned pozzolans can be used as an alternative material for cement.
1 January 2017 in KSCE Journal of Civil Engineering
The utilization of pozzolans in cementitious system (concrete and mortar) minimizes both cost and energy. It also enhances mechanical strength and durability of the system. The total contribution of pozzolans can be categorized into two: (i) physical or filler effect which is attributed by the fineness of the particles and (ii) chemical or pozzolanic effect which is attributed by the pozzolanic reaction. It is difficult to quantify the strength development of cementitious system caused by the filler and pozzolanic effect separately. Therefore, the individual contribution of pozzolans in cementitious system because of its physical and chemical effects need to be profoundly understood by the scientific community. This paper reviews available literatures to understand the effect of non-reactive fillers that attributed as the microfiller effect of pozzolans in cementitious systems. The previous studies utilized chemically inactive materials that attributed only the microfiller activity of pozzolans for a partial replacement of cement. It was reported that filler effect is equal or sometimes more significant than pozzolanic effect in concrete. A larger range of replacement percentages (like 5%, 10%, 15% or 10%, 20%, 30% etc.) was used in the previous studies. However, probabilities of the optimum compressive strength because of the filler effect may lie in between two larger range of replacement percentages. Therefore, an experimental work is also carried out using natural ground sand of size 7.6-μm at a lower range of cement replacement percentages (like 2.5%, 5%, 7.5% etc.) in mortar. Compressive strength of mortar at different ages and microstructure analysis of mortar at 28 days were performed in this study. Test results showed that the filler effect is more pronounced at a lower replacement percentages of cement (0-10%) while using smaller non-reactive fillers. The maximum strength due to filler effect of ground sand is acheieved at 7.5% replacement of cement. Scanning Electron Microscope (SEM) images also confirmed the effect of fillers on the microstructure development of mortar.
This study examined the efficacy of waste glass cullet (WGC) as a substitute for natural fine aggregate in alkali-activated composites when exposed to sulfuric acid and hydrochloric acid solutions for 1 year. The physical appearance, surface alkalinity, mass, mechanical strength and microstructure of hardened samples before and after immersion in acid solutions were investigated. The findings this work indicated that physical, mechanical and microstructural damage of the specimens due to acid attack increased with an increase in the percentage of WGC. This was attributed to the smooth surface texture and angularity of the WGC, which affected the bond with the damaged paste matrix at the interfacial transition zone and increased the porosity. However, the acid resistance of the mortars containing up to 50% WGC was found to be satisfactory when compared with the mortar without WGC. Therefore, the use of WGC as a partial replacement (up to 50%) for natural sand is feasible for alkali-activated systems under acid exposure.