This review highlights the main strategies available to control phage infection during large-scale milk fermentation by lactic acid bacteria. The topics that are emphasized include the factors infl...
This review focuses on the impact of bacteriophages on the manufacture of dairy foods. Firstly, the impact of phages of lactic acid bacteria in the dairy industry, where they are considered enemies, is discussed. The sources of phage contamination in dairy plants are detailed, with special emphasis on the rise of phage infections related to the growing use of cheese whey as ingredient. Other topics include traditional and new methods of phage detection, quantification and monitoring, and strategies of phage control in dairy plants, either of physical, chemical or biological nature. Finally, the use of phages or purified phage enzymes as allies to control pathogenic bacteria in the food industry is reviewed.
1 July 2003 in International Journal of Food Microbiology
Aim: To investigate the influence of several environmental factors on the viability and cell-adsorption for two Lactobacillus casei/paracasei bacteriophages (PL-1 and J-1). Methods and Results: Both phages showed a remarkably high specificity of species, sharing similar host spectra. Two phages and four sensitive strains were used to conform five phage/strain systems. Each showed a particular behaviour (burst size: ranging from 32 to 160 PFU/infective centre; burst time: 120–240 min and latent time: 5–90 min). For both phages, the viability was not significantly affected from pH 4 to 11 (room temperature) and from pH 5 to 10 (37°C). Adsorption rates were not influenced by calcium ions, but decreased after the thermal inactivation of cells. Adsorption rates were high between 0 and 50°C with maximum values at 30°C and pH 6. System PL-1/Lact. paracasei A showed noticeable differences in comparison with the others, being times required to reach 90% of adsorption of 4 h and lower than 45 min, respectively. Conclusions: The data obtained in this work demonstrated that environmental parameters can influence the viability and cell adsorption rates of Lact. casei/paracasei phages. The extent of this influence was phage dependent. Significance and Impact of the Study: This work contributes to the enlargement of the currently scarce knowledge of phages of probiotic bacteria.
Bacteriophages can cause great economic losses due to fermentation failure in dairy plants. Hence, physical and chemical treatments of raw material and/or equipment are mandatory to maintain phage levels as low as possible. Regarding thermal treatments used to kill pathogenic bacteria or achieve longer shelf-life of dairy products, neither low temperature long time nor high temperature short time pasteurization were able to inactivate most lactic acid bacteria (LAB) phages. Even though most phages did not survive 90°C for 2 min, there were some that resisted 90°C for more than 15 min (conditions suggested by the International Dairy Federation, for complete phage destruction). Among biocides tested, ethanol showed variable effectiveness in phage inactivation, since only phages infecting dairy cocci and Lactobacillus helveticus were reasonably inactivated by this alcohol, whereas isopropanol was in all cases highly ineffective. In turn, peracetic acid has consistently proved to be very fast and efficient to inactivate dairy phages, whereas efficiency of sodium hypochlorite was variable, even among different phages infecting the same LAB species. Both alkaline chloride foam and ethoxylated non-ylphenol with phosphoric acid were remarkably efficient, trait probably related to their highly alkaline or acidic pH values in solution, respectively. Photocatalysis using UV light and TiO2 has been recently reported as a feasible option to industrially inactivate phages infecting diverse LAB species. Processes involving high pressure were barely used for phage inactivation, but until now most studied phages revealed high resistance to these treatments. To conclude, and given the great phage diversity found on dairies, it is always advisable to combine different anti-phage treatments (biocides, heat, high pressure, photocatalysis), rather than using them separately at extreme conditions.