A validated standard k-ε model was used to investigate the effects of ground heating on ventilation and pollutant transport in a three-dimensional (3D) street canyon. Air entered the street canyon from the upper regions of side surfaces and most areas of the top surface and left from the lower regions of side surfaces. Ground heating enhanced the mean flow, ventilation, and turbulence, and facilitated pollutant reduction inside street canyons. The transport patterns in a street canyon that included a pollutant source (PSC) and a target street canyon downstream (TSC) were different. The pollutant did not enter the PSC, and turbulent diffusion dominated pollutant outflow at all boundaries. The pollutant entered the TSC from most regions of the side surfaces and exited from lower regions of the side surfaces and the entire top surface. Air convection dominated pollutant transport at the side surfaces, and its contribution increased significantly with ground temperature; Furthermore, turbulent diffusion dominated pollutant outflow for the top surface, and its contribution increased slightly with ground heating. As revealed by an analysis of both the total pollutant flow rates and air flow rates, although air/pollutant exchange between the TSC and outer space occurred primarily through the side surfaces, the increase in air inflow from the top surface reduced the pollutant concentration inside the street canyon when the ground temperature increased. The top surface played a major role in improving air quality in a 3D environment with ground dispersion. This study supplied valuable suggestions for urban planning strategies. The analyzing method used in this research is helpful for the pollutant transport investigations in urban areas.

With increasing urbanization, urban air pollutants are becoming more and more relevant to human health. Here, combined with meteorological observation data, a numerical simulation of typical urban blocks in Shanghai was carried out to understand the spread of air pollutants caused by road traffic sources (ground–level and viaduct–level). Firstly, we analyzed the wind environment characteristics. Then, we quantitatively analyzed the pollutant distribution profiles and the contributions of two pollutant sources (PSV). Finally, we analyzed seven urban morphological parameters based on ventilation efficiency indices. Results revealed the following. (1) Ventilation patterns within the architectural complex are determined by local geometry; (2) Pollutants released at ground level were dominant when the Z–plane < 8 m high, and pollutants released from the viaduct source were 0.8–6.1% higher when the Z–plane ≥ 8 m high; (3) From ground level to a height of 60 m, the spatially–averaged normalized concentration (C*) tended to decrease gradually with distance from the source. C* increased irregularly with an increase in distance between 60 m and 86 m. Above 86 m, C* tended to increase linearly; (4) Vertical profiles of C* around buildings were building–specific, and their rate of change was inconsistent with height increases. In general, the correlations between C* and VR_w, and between C* and KE_turb were larger on the windward side of PSV upstream buildings than on the leeward side. Buildings downstream of the PSV showed the opposite situation; (5) At pedestrian level, the seven urban morphological parameters had no significant correlation with VR_w, C_ir*, and C_zs*.