Recently, 3D printing as effective technology has been highlighted in the biomedical field. Previously, a porous hydroxyapatite (HA) scaffold with the biocompatibility and osteoconductivity has been developed by this method. However, its osteoinductivity is limited. The main purpose of this study was to improve it by the introduction of recombinant human bone morphogenetic protein-2 (rhBMP-2). This scaffold was developed by coating rhBMP-2-delivery microspheres with collagen. These synthesized scaffolds were characterized by Scanning Electron Microscopy (SEM), a delivery test in vitro, cell culture, and the experiments in vivo by a Micro-computed tomography (μCT) scan and histological evaluation of VanGieson staining. SEM results indicated the surface of scaffolds were more fit for the adhesion of hMSCs to coat collagen/rhBMP-2 microspheres. Biphasic release of rhBMP-2 could continue for more than 21 days, and keep its osteoinductivity to induce osteogenic differentiation of hMSCs in vitro. In addition, the experiments in vivo showed that the scaffold had a good bone regeneration capacity. These findings demonstrate that the HA/Collagen/Chitosan Microspheres system can simultaneously achieve localized long-term controlled release of rhBMP-2 and bone regeneration, which provides a promising route for improving the treatment of bone defects.
Additive manufacturing or three-dimensional (3D) printing technology is increasingly being employed in biochemical as well as clinical applications and more importantly in fabrication of microfluidic devices. However, the microfluidic community mainly relies on photolithography for fabrication of a defined mask, which is both tedious and expensive requiring clean room settings as well as limited to the generation of two-dimensional features. In this work, we 3D printed nanoclay-reinforced Pluronic ink as a sacrificial material, which exhibited shear thinning behavior and superior printability allowing the fabrication of unsupported or overhanging templates of channels with uniform diameter and circular cross-sections. To highlight the potential and effectiveness of the presented approach, we fabricated a human blood vessel-on-a-chip model with curved as well as straight channels. These channels were then lined up with human umbilical vein endothelial cells (HUVECs) and subjected to a dynamic culture for 10 d to explore the effect of shear stress on HUVEC morphology based on the location of HUVECs in the devices. Overall, we presented a highly affordable, practical and useful approach in manufacturing of polydimethylsiloxane-based devices with closed microfluidic channels, which holds great potential for a numerous applications, such as but not limited to organ-on-a-chip, microfluidics, point-of-care devices and drug screening platforms.