The purpose of this methodological study was to test whether similar soil hydraulic and solute transport properties could be estimated from field plots and lysimeter measurements. The transport of water and bromide (as an inert conservative solute tracer) in three bare field plots and in six bare soil lysimeters were compared. Daily readings of matric head and volumetric water content in the lysimeters showed a profile that was increasingly humid with depth. The hydrodynamic parameters optimized with HYDRUS-1D provided an accurate description of the experimental data for both the field plots and the lysimeters. However, bromide transport in the lysimeters was influenced by preferential transport, which required the use of the mobile/immobile water (MIM) model to suitably describe the experimental data. Water and solute transport observed in the field plots was not accurately described when using parameters optimized with lysimeter data (cross-simulation), and vice versa. The soil’s return to atmospheric pressure at the bottom of the lysimeter and differences in tillage practices between the two set-ups had a strong impact on soil water dynamics. The preferential flow of bromide observed in the lysimeters prevented an accurate simulation of solute transport in field plots using the mean optimized parameters on lysimeters and vice versa.
Limestone aquifers constitute important drinking water resources but are vulnerable to groundwater contaminations. They are also known to be often heterogeneous. However, the hydraulic properties of their entire vadose zone and the relationship of these hydraulic properties with their mineralogical and geochemical characteristics remain rarely studied. The hydraulic properties of soft (soil, powdery limestone, and calcareous sand) and hard (limestone rock) materials sampled throughout the entire vadose zone profile of the Beauce limestone aquifer (France) were determined with the multistep outflow method applied using a triaxial system. Physical, mineralogical, and geochemical analysis brought valuable information about factors contributing to the heterogeneity of the hydraulic properties and helped understanding water flow pathways within the vadose zone. The hydraulic properties of the soft materials were strongly related to their physical properties but also to the proportion and the nature of clay minerals. The massive rock presented a few thin microfissures where calcite was replaced by phyllosilicates, thus increasing its water retention capacity. The low hydraulic conductivity of the massive rock could explain the occurrence of perched water tables in the vadose zone. The weathered rock displayed fissures and vugs and was also characterized by the presence of phyllosilicates. The development of a secondary porosity and footprints of water–rock interactions and mass transfers highlighted the transformation of the limestone rock into a more permeable material. This study also pointed out the need to characterize the impact of natural fractures observed at the core scale on the preferential water flow at the field scale.
Water retention and hydraulic conductivity are the most important properties governing water flow and solute transport in unsaturated porous media. However, transport processes in the vadose zone (VZ) are still not completely understood, in spite of their importance for the preservation and management of aquifers, especially in the geographic zones under intensive agriculture. This study has been carried out as part of the construction of the O-ZNS platform (Observatory of transfers in the vadose zone). This platform aims to integrate observations over a wide range of spatial and temporal scales thanks to a large access well (depth–20 m & diameter–4m) surrounded by several boreholes in order to combine broad characterization and focused monitoring techniques.Three cored boreholes have been drilled in Spring 2017. Structural and mineralogical analyses were carried out for four types of materials sampled throughout the entire VZ profile (20 m depth) including soft sediments (soil, marl and sand) and fractured limestone rock. Hydraulic properties (q(h) and K(h)) were measured on representative core samples by means of a triaxial system used by applying the multistep outflow method. Simulations were then made using HYDRUS-1D to simulate water flow and bromide (conservative tracer) transport over 50 years using meteorological and water table level data.The results brought valuable information about factors contributing to the heterogeneity of hydraulic properties within the VZ. For the applied matric heads (from 0 to -1000 cm), the water content and hydraulic conductivity of (i) the soft materials (9 samples) ranged from 0.173 to 0.485 cm3/cm3 and from 1.26.10-5 to 2.41 cm/d, respectively ; (ii) the hard materials (5 samples) ranged from 0.063 to 0.340 cm3/cm3 and from 8.54.10-5 to 1.82 cm/d, respectively. The shape of the water retention and hydraulic conductivity curves obtained for the soft sediments is strongly related to the physical properties of the material but also to the proportion and the nature of clay minerals. The soil material displayed the largest average water retention capacity due to the presence of smectite and kaolinite, indicating weathering and matrix transformation. The water retention capacity of the marl and sand materials was lower due to higher content in palygorskyte and calcite. The limestone rock materials displayed an important heterogeneity in their hydraulic properties. Mineralogical analysis helped understanding water flow pathways within the limestone aquifer. The non-altered matrix, that seemed impermeable at first sight, presented few thin microfractures where water probably accumulates. The altered matrix showed microfractures where water has circulated and calcite has been replaced by phyllosilicates, thus increasing the water retention capacity. Natura macrofractures observed at dm-scale showed the presence of iron oxides which highlighted an exposure to high water flow. Simulations made using HYDRUS-1D allowed a first estimation of water and solutes travel time through this highly heterogeneous vadose zone. The results highlighted transfer time of between 25 to 35 years for the bromide to reach water table. The differences observed between the three cored boreholes were mainly due to the heterogeneity of the marl materials located between 1 and 7 m deep.
The extent and the fluid dynamics of the vadose zone (VZ) of an aquifer have a direct impact on the aquifer recharge, the water quality and the pollutants transfer from the soil to the groundwater. The water – rock interactions and mass and heat transfers under the impact of microbial processes and agricultural practices could undergoes significant changes in the chemical composition of the water flowing throughout the VZ, which may induce pollution of groundwater.The growing dependence on groundwater for potable water supplies draws attention to protect the quality of groundwater resources at national and international levels to the need. It is important to detect the contamination risk of aquifers and develop an integrated water management methodology based on innovative environmental monitoring tools and sophisticated numerical models to protect groundwater resources and guarantee their good quality for domestic, agricultural and industrial needs. For this reason, the monitoring of VZ dynamics has become essential to study the transfer mechanisms of mass (water, gas and contaminants) and heat from the soil to the groundwater. This should allow rapid detection of the pollutants migration through an aquifer and take relevant measures to protect groundwater before the contaminants reach the water table.In this context, an Observatory of transfers in the vadose zone (O-ZNS) is being developed at Villamblain (Orléans, France) in an agricultural field. The O-ZNS project consists of a well with a diameter of 4 m and a depth of 20 m which will allow access to the entire VZ of the Beauce aquifer. The main target of the O-ZNS platform is to acquire original and unique data on the reactive transfers of fluids and heat in the VZ, in order to follow in situ and in real time the highly coupled physical, chemical, and biological processes taking place over the long term. The O-ZNS project also aims to assess the performance of all types of instrumentation dedicated to non-destructive measurement or local sampling of fluids, rocks, and microbs in the VZ for long duration.To meet these objectives, a myriad of innovative monitoring tools (e.g.,environmental sensors, fiber optic sensors, geophysical imaging, ….) will be deployed in the O-ZNS from the soil surface to the aquifer (from 0 to 20 m deep) using the well and the surrounding boreholes. Also, note that to date, there are still difficulties in the instrumentation of rock materials and relevant solutions must be developed. These environmental monitoring techniques will allow to generate a huge quantity of data on the physical, chemical, and microbiological coupled processes.
The geological and petrophysical properties of the Vadose Zone (VZ) play a major role in the reactive transport of contaminants and fluid dynamics in fractured media and karstic hydrosystems. The mass and heat transfers through the VZ are governed by numerous complex and coupled processes, which control the fate of pollutants and influence the quality of groundwater resources. The current scientific research aimed at deciphering these hydrological and biogeochemical processes thanks to multi-scale laboratory experimentations and field observations. In order to acquire observation data over a wide range of spatial (nm- to km-) and temporal (minutes to decades) scales, an Observatory of transfers in the Vadose Zone (O-ZNS) is being developed at Villamblain (Orléans, France) in an agricultural field. The O-ZNS project consists of an access well with a diameter of 4 m and a depth of 20 m surrounded by several boreholes which will provide access to the entire VZ of the Beauce aquifer. The main target of the O-ZNS project is to acquire high resolution data on the reactive transfers of mass and heat in the VZ, in order to follow in situ and in real time the highly coupled physical, chemical, and biological processes taking place over the long term and at different various scales.To meet the scientific objectives of the project, several sensors and environmental monitoring techniques are being considered as part of the instrumentation of the O-ZNS site. The preliminary geological, geochemical, and hydrogeological investigations conducted at the laboratory scale and coupled with a multi-methods geophysical sounding undertaken at the field scale generated valuable information on the lithological and hydraulic properties of the highly heterogeneous VZ facies. Based on these results, a first estimation of the mean water travel time of 29 years for an inert solute to reach the water table level (15 m deep) was given.In this context, three distributed optical fiber sensors (temperature “DTS”, deformation “DSS”, and acoustic “DAS”) were installed in July 2020 along three boreholes surrounding the main observatory well and were connected to a data center. These sensors will allow the monitoring of fluid circulation, the rock fractures characterization, and the micro-movements detection in the VZ of the Beauce aquifer. Many innovative hydrogeological solutions are also being considered for the monitoring of fluids and solutes transport in VZ. These sensors include: water content probes for deep VZ materials, multi-level water sampler systems, and new generation of lysimeters allowing the study of contaminants transfer at an intermediate scale between laboratory and field. A latest-generation multiparameter probe will also be installed in February 2021 in the O-ZNS piezometer to monitor the variations of the water level and the quality of the groundwater. To complete these sensors, geophysical imagery will be deployed at different scale to link all parameters together in a 3D model.This whole set of devices will provide a better understanding of the mass and heat transfer processes within the whole VZ column of the Beauce aquifer and some of the key compartments of the critical zone.