Evaporation of a binary mixture droplet (BMD) is a common natural phenomenon and widely applied in many industrial fields. For the case of a sessile BMD being the only contact-line pinning throughout an entire evaporation, a theoretical model describing the evaporating dynamics is established when considering the comprehensive effect of evaporative cooling, the thermal Marangoni effect, the solutal Marangoni effect, the convection effect, and the Stefan flow. The dynamics of a binary ethanol–water droplet on a heated substrate is simulated using a cylindrical coordinate system. The reasons for Marangoni instability-driven flow (MIF) are discussed, and the influence of initial ethanol concentration and substrate heating temperature are examined. An evaporating BMD first forms a MIF at the contact line and quickly affects the whole droplet. Under the influence of the Marangoni instability, the BMD presents a complex internal flow structure with multiple-vortex and nonlinear temperature and ethanol concentration distributions. The positive feedback induced by vortices and the nonlinear distribution of concentration and temperature promotes the development of a MIF. At low initial ethanol concentrations, the MIF loses its driving force and turns into a stable counterclockwise single-vortex flow as ethanol evaporates completely. However, at high initial ethanol concentrations, the MIF exists in the entire evaporation. Increasing ethanol concentration and substrate heating temperature can delay the appearance of the MIF; ethanol concentration affects the MIF duration time, and heating temperature alters the MIF intensity. To enhance flow intensity and mass transfer of BMDs, the temperature difference should first be increased, followed by increased ethanol concentration.
Based on the given parabolic gas-liquid interfaces, a two-dimensional fluid flow in superhydrophobic microchannels is numerically simulated with the steady volume of fluid model in the laminar regime. The influence of several crucial parameters on drag reduction effect is discussed. The results indicate that the superhydrophobic microchannel containing rectangular cavities displays significant drag reduction effect. With increasing inlet velocity, the pressure drop reduction decreases slightly. Augments in the pressure drop reduction tend to be large with the increase of the cavity fraction or the decrease of the channel height. The results also reveal that the variation of the normalized slip length with the cavity fraction tends to be more dramatic when the channel height is smaller. As the parabolic height of the gas-liquid interface is enlarged, both the pressure drop reduction and the normalized slip length decrease linearly, while fRe increases linearly. The impact of the cavity depth on the normalized slip length, fRe, and the pressure drop reduction is minimal supposing the depth of the cavity is greater than 40% of its width. The drag reduction effect corresponding to the dovetail cavity model is the best, and the consequence of the rectangular, trapezoidal, and triangular cavity models sequentially worsens.