As this study examined the issue of surface acoustic wave (SAW) torque sensor which interfered in high rotational speed, the gyroscopic effect generated by rotation was analyzed. Firstly, the SAW coupled equations which contained torque and rotation loads were deduced, and the torque calculation error caused by rotation was solved. Following this, the hardware of the SAW gyroscopic effect testing platform and the turntable experiment were designed to verify the correctness of the theoretical calculation. Finally, according to the experimental data, the gyroscopic effect was compensated by multivariate polynomial fitting (MPF), Gaussian processes regression (GPR), and least squares support vector machine algorithms (LSSVM). The comparison results showed that the LSSVM has the obvious advantage. For improving the function of LSSVM model, chaos estimation of distributed algorithm (CEDA) was proposed to optimize the super parameters of the LSSVM, and numerical simulation results showed that: (1) CEDA is superior to traditional estimation of distributed algorithms in convergence speed and anti-premature ability; (2) the performance of CEDA-LSSVM is better than genetic algorithms (GA)-LSSVM and particle swarm optimization (PSO)-LSSVM. After compensating by CEDA-LSSVM, the magnitude of the torque calculation relative error was 10−4 in any direction. This method has a significant effect on reducing gyroscopic interference, and it lays a foundation for the engineering application of SAW torque sensor.
Due to their unique advantages, surface acoustic wave (SAW) sensors have attracted various disciplines to carry out thorough research. However, in their wireless applications, their high carrier frequency, low signal-to-noise ratio, and short effective signal length have led to poor signal measurement accuracy and complex detection systems. Using an SAW torque sensor as its objective, this paper describes the proposal and completion of a novel processing system based on compressive sensing (CS). The system was implemented using an analog-to-information conversion module. The module hardware’s structural parameters and signal recovery parameters were designed and optimized by simulation. Furthermore, an intervening interpolation method based on support vector machine (SVM) signal secondary information prediction was developed to achieve an effective extension of the observed signal. The method’s parameters and the SVM super parameters were optimized by a cuckoo search algorithm. The success rate of the predicted signal secondary information reached more than 94%. The compression ratio of the system reached 5.77‰ while ensuring successful signal frequency recovery. Finally, a torque static calibration experiment was carried out using the system prototype; the results show that the system sensitivity is 1.951 kHz Nm −1 , which proves that the scheme and methods are effective. The SAW signal-processing system based on CS combines the advantages of traditional demodulation system solutions with low hardware costs, low data volume, and high interference immunity. This system will prompt some new thoughts about SAW sensor signal detection.
Surface acoustic wave (SAW) sensing systems based on the received signal strength indication (RSSI) detection principle have recently gained considerable research attention because of their distinct advantages and disadvantages. However, the test mode requires constant sweeping, which severely limits the system’s dynamic response; to overcome this limitation, an effective solution is to establish a suitable eigenvalue search strategy to replace naive sweeping. To this end, a basis for this process is established in this study. Furthermore, the mechanism of the SAW sensing system based on RSSI detection is analyzed, a system model is established by introducing sequence signal superposition, and the model’s validity is verified via experiments. Signal variations at each stage and model errors are analyzed, and the system’s timing parameters are optimized. Finally, using the SAW torque sensor, an optimized torque measurement prototype is designed and the system’s effectiveness is verified through static torque experiments. A complete model of the measurement system can be simulated through this model; it provides the basis for an eigenvalue search strategy and can act as a simulation model or design basis for other researchers building RSSI-detection-based SAW sensing systems.