In this work, we present studies on the effect of laser wavelengths on the laser-induced plasma characterization using a femtosecond (fs) ytterbium-doped potassium-gadolinium tungstate (Yb:KGW) laser. Plasma plumes of copper, steel, ceramics, and glass samples were induced using a multiple shot of 200 fs laser pulses with 1030 nm and 343 nm wavelengths at fixed laser fluence ([ ]) and analyzed using the laser-induced breakdown spectroscopy (LIBS) technique. Time-resolved fs-LIBS measurements were performed on the same set of samples and under the same experimental conditions. For the calculation of plasma parameters, the set of spectral lines of Cu(I) (for copper sample), Fe(I) (for steel sample), and Ca(I), K(I) (for glass and ceramics samples) were observed. The plasma electron temperature and density were evaluated from the Boltzmann plots and Stark-broadening profiles of the plasma spectral lines, assuming the local thermodynamic equilibrium condition. Time-resolved plasma temperature and electron density for fs-LIBS using ultraviolet (UV) and infrared (IR) laser wavelengths were analyzed and no significant dependence on fs laser wavelength was observed for any of the samples. However, for all samples the signal-to-noise ratio (SNR) significantly increased using UV laser radiation: copper ([ ]), steel ([ ]), glass ([ ]), and ceramics ([ ]). Therefore, by using a fs UV laser wavelength for laser-induced breakdown spectroscopy experiments, for certain materials the SNR and at the same time the limit of detection can be significantly enhanced.

Space and time-resolved electron density and temperature of the plasma, created in air by focused femtosecond laser pulses have been investigated as a function of the pump pulse energy and duration. For the air ionization the infrared (1030 nm) femtosecond (190–500 fs) Yb:KGW laser pulses of up to 1 mJ energy were used. Based on the Stark broadening of the oxygen-I 777.19 nm line we have found that after establishing a local equilibrium the density of laser-created plasma could exceed 10 ¹⁷ cm ⁻³ with the electron temperature of over 5000 °C. Obtained results agree well with the results of previously reported measurements of the plasma density created by the femtosecond near-infrared Ti:sapphire laser pulses.

We report here the results of comprehensive plasma characterization and diagnostics by analyzing time-resolved absorption spectra of short ultrabroadband (0.1–50 THz) pulses propagated through the test plasma. Spectral analysis of plasma-induced absorption of such THz pulses provides very direct, in situ, high dynamical range, potentially single-shot access to the plasma density, plasma decay time, electron temperature, and ballistic dynamics of the plasma expansion. We have demonstrated a proof-of-principle measurement of plasma created by an intense laser beam. In particular, we showed a reliable measurement of plasma densities from around ${10}^{16}$ to ${10}^{20}{\mathrm{cm}}^{-3}$. Apart from the plasma parameters, this method allowed us to reconstruct peak intensity inside the plasma spot and to observe a very early stage of plasma evolution after its excitation.

We have studied femtosecond ablation of soda–lime glass sample under thin water film, under KOH and NaCl aqueous solutions films and their influence and benefits compared with ablation in the air atmosphere. These have been studied in case of the groove ablation using the infrared (IR) femtosecond laser. KOH aqueous solution film above the glass sample improved the ablation efficiency and led to the formation of the grooves with a higher aspect ratio when multi-scan glass cutting conditions were applied.