A highly loaded design method of helium compressor is presented in this paper. First, particular loss prediction models based on corrections of isentropic index and velocity triangle are deduced for highly loaded helium compressor. Then the influence of design parameters such as reaction, flow coefficient and load coefficient on aerodynamic loss of highly loaded helium compressor is analyzed in detail with the loss models. The design principles are also discussed. A highly loaded helium compressor design study is carried out based on a 300-MW high-temperature gas-cooled reactor (HTGR) helium multistage compressor to validate the method. The results indicate that the 16-stage helium low-pressure compressor of the 300-MW HTGR can be reduced to a 3-stage compressor by the proposed highly loaded design method at the same tip tangential velocity. The isentropic efficiency could be as high as 90% under design condition.
1 November 2016 in Journal of Propulsion and Power
The rotor dynamics and flow characteristics of a seal-rotor system for a straight-through seal and a corresponding interlaced labyrinth seal were computed. The most significant parameters of the rotor dynamic, such as frequency and amplitude of vibration, were determined by numerical methods. These parameters were then used in an unsteady fluid flow simulation. The numerical results indicated that rotor vibration could increase leakage flow and give rise to an additional aerodynamic force that could act on the rotor. Aerodynamic force produced by the straight-through labyrinth seal tended to reduce the self-excited vibration of the rotor, and this effect became more apparent with an increase in pressure difference, which penetrated the seals. The opposite case resulted in the numerical results of the interlaced labyrinth seal. It was found that the vortex and pressure distribution in the seal cavities was the primary cause of these results. Differences between the two types of labyrinth seals were presented in this research.