Purpose – This paper aims to study different possibilities for implementing easy-to-use and cost-effective micro-systems to detect and trace expelled gases from rotten food. The paper covers various radio-frequency identification (RFID) technologies and gas sensors as the two promoting feasibilities for the tracing of packaged food. Monitoring and maintaining quality and safety of food in transport and storage from producer to consumer are the most important concerns in food industry. Many toxin gases, even in parts per billion ranges, are produced from corrupted and rotten food and can endanger the consumers’ health. To overcome the issues, intelligent traceability of food products, specifically the packaged ones, in terms of temperature, humidity, atmospheric conditions, etc., has been paid attention to by many researchers. Design/methodology/approach – Food poisoning is a serious problem that affects thousands of people every year. Poisoning food must be recognized early to prevent a serious health pro...
7 February 2017 in Journal of Materials Science: Materials in Electronics
Despite SIESTA and COMSOL being increasingly used for the simulation of the sensing mechanism in the gas sensors, there are no modeling and simulation reports in literature for detection of NO2 based rGO/SnO2 sensors. In the present study, we model, simulate, and characterize an NO2 based rGO/SnO2 gas sensor using COMSOL by solving the Poisson’s equations under associated boundary conditions of mass, heat and electrical transitions. To perform the simulation, we use an exposure model for presenting the required NO2, a heat transfer model to obtain a reaction temperature, and an electrical model to characterize the sensor’s response in the presence of the gas. We characterize the sensor’s response in the presence of different concentrations of NO2 at different working temperatures and compare the results with the experimental data, reported by Zhang et al. The results from the simulated sensor show a good agreement with the real sensor with some inconsistencies due to differences between the practical conditions in the real chamber and applied conditions to the analytical equations. The results also show that the method can be used to define and predict the behavior of the rGO-based gas sensors before undergoing the fabrication process.
A gas sensor array was developed in a 10 × 10 mm2 space using Screen Printing and Pulse Laser Ablation Deposition (PLAD) techniques. Heater, electrode, and an insulator interlayer were printed using the screen printing method on an alumina substrate, while tin oxide and platinum films, as sensing and catalyst layers, were deposited on the electrode at room temperature using the PLAD method, respectively. To ablate SnO2 and Pt targets, depositions were achieved by using a 1,064 nm Nd-YAG laser, with a power of 0.7 J/s, at different deposition times of 2, 5 and 10 min, in an atmosphere containing 0.04 mbar (4 kPa) of O2. A range of spectroscopic diffraction and real space imaging techniques, SEM, EDX, XRD, and AFM were used in order to characterize the surface morphology, structure, and composition of the films. Measurement on the array shows sensitivity to some solvent and wood smoke can be achieved with short response and recovery times.
Microstructural, topology, inner morphology, and gas-sensitivity of mixed xWO3(1-x)Y2O3 nanoparticles (x = 1, 0.95, 0.9, 0.85, 0.8) thick-film semiconductor gas sensors were studied. The surface topography and inner morphological properties of the mixed powder and sensing film were characterized with X-ray diffraction (XRD), atomic force microscopy (AFM), transmission electron microscopy (TEM), and scanning electron microscopy (SEM). Also, gas sensitivity properties of the printed films were evaluated in the presence of methane (CH4) and butane (C4H10) at up to 500 °C operating temperature of the sensor. The results show that the doping agent can modify some structural properties and gas sensitivity of the mixed powder.