In the polymerization of caprolactam, the stoichiometry of carboxyl groups and amine groups in the process of melt polycondensation needs to be balanced, which greatly limits the copolymerization modification of polyamide 6. In this paper, by combining the characteristics of the polyester polymerization process, a simple and flexible synthetic route is proposed. A polyamide 6-based polymer can be prepared by combining caprolactam hydrolysis polymerization with transesterification. First, a carboxyl-terminated polyamide 6-based prepolymer is obtained by a caprolactam hydrolysis polymerization process using a dibasic acid as a blocking agent. Subsequently, ethylene glycol is added for esterification to form a glycol-terminated polyamide 6-based prepolymer. Finally, a transesterification reaction is carried out to prepare a polyamide 6-based polymer. In this paper, a series of polyamide 6-based polymers with different molecular weight blocks were prepared by adjusting the amount and type of dibasic acid added, and the effects of different control methods on the structural properties of the final product are analyzed. The results showed that compared with the traditional polymerization method of polyamide 6, the novel synthetic strategy developed in this paper can flexibly design prepolymers with different molecular weights and end groups to meet different application requirements. In addition, the polyamide 6-based polymer maintains excellent mechanical and hygroscopic properties. Furthermore, the molecular weight increase in the polyamide 6 polymer is no longer dependent on the metering balance of the end groups, providing a new synthetic route for the copolymerization of polyamide 6 copolymer.

Using 2,5-furandicarboxylic acid, ethylene glycol, and poly(ethylene glycol) as raw materials and ethylene glycol antimony as a catalyst, poly(ethylene furandicarboxylate) (PEF) and polyethylene glycol (PEG) copolymers (PEGFs) were synthesized by transesterification by changing the molecular weight of PEG (from 600 to 10,000 g/mol) and the PEG content (from 10 to 60 wt %). The thermal, hydrophilic, degradation, and spinnility characteristics of these copolymers were then investigated. Thermogravimetric analysis shows that PEGF is thermally stable at 62 °C, much lower than the temperature for PEF. The intrinsic viscosity of the obtained copolyester was between 0.67 and 0.99 dL/g, which is higher than the viscosity value of PEF. The contact angle experiment shows that the hydrophilicity of PEGFs is improved (the surface contact angle is reduced from 91.9 to 63.3°), which gives PEGFs a certain degradability, and the maximum mass loss can reach approximately 15%. Melt spinning experiments show that the PEGF polymer has poor spinnability, but the mechanical properties of the polymer monofilament are better.