Nanostructured anodic oxide layers on an FeAl3 intermetallic alloy were prepared by two-step anodization in 20 wt% H2SO4 at 0 °C. The voltage range was 10.0–22.5 V with a step of 2.5 V. The structural and morphological characterizations of the received anodic oxide layers were performed by field emission scanning electron microscopy (FE-SEM). Therefore, the formed anodic oxide was found to be highly porous with a high surface area, as indicated by the FE-SEM studies. It has been shown that the morphology of fabricated nanoporous oxide layers is strongly affected by the anodization potential. The oxide growth rate first increased slowly (from 0.010 μm/s for 10 V to 0.02 μm/s for 15 V) and then very rapidly (from 0.04 μm/s for 17.5 V up to 0.13 μm/s for 22.5 V). The same trend was observed for the change in the oxide thickness. Moreover, for all investigated anodizing voltages, the structural features of the anodic oxide layers, such as the pore diameter and interpore distance, increased with increasing anodizing potential. The obtained anodic oxide layer was identified as a crystalline FeAl2O4, Fe2O3 and Al2O3 oxide mixture.
Anodization of Ni3Al alloy is of interest in the field of industrial manufacturing, thanks to the formation of protective oxide layer on the materials working in corrosive environments and high temperatures. However, homogeneous surface treatment is paramount for technological applications of this material. The anodization conditions have to be set outside the ranges of corrosion and “burning”, which is the electric field enhanced anodic dissolution of the metal. In order to check against occurrence of these events, proper quantitative means for assessing the surface quality have to be developed and established. We approached this task by advanced analysis of scanning electron microscope images of anodized Ni3Al plates. The anodization was carried out in 0.3 M citric acid at two temperatures of 0 and 30°C and at voltages in the range of 2 12 V. Different figures can be used to characterize the quality of the surface, in terms of uniformity. Here, the concept of regularity ratio spread is used for the first time on surfaces of technological interest. Additionally, the Minkowski parameters have been calculated and their meaning is discussed.