Iron ore was studied as a CO2 absorbent. Carbonation was carried out by mechanochemical and high temperature–high pressure (HTHP) reactions. Kinetics of the carbonation reactions was studied for the two methods. In the mechanochemical process, it was analyzed as a function of the CO2 pressure and the rotation speed of the planetary ball mill, while in the HTHP process, the kinetics was studied as a function of pressure and temperature. The highest CO2 capture capacities achieved were 3.7341 mmol of CO2/g of sorbent in ball milling (30 bar of CO2 pressure, 400 rpm, 20 h) and 5.4392 mmol of CO2/g of absorbent in HTHP (50 bar of CO2 pressure, 100 °C and 4 h). To overcome the kinetics limitations, water was introduced to all carbonation experiments. The calcination reactions were studied in Argon atmosphere using thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC) analysis. Siderite can be decomposed at the same temperature range (100 °C to 420 °C) for the samples produced by both methods. This range reaches higher temperatures compared with pure iron oxides due to decomposition temperature increase with decreasing purity. Calcination reactions yield magnetite and carbon. A comparison of recyclability (use of the same material in several cycles of carbonation–calcination), kinetics, spent energy, and the amounts of initial material needed to capture 1 ton of CO2, revealed the advantages of the mechanochemical process compared with HTHP.
19 April 2021 in Brazilian Journal of Chemical Engineering
Se presenta un estudio sobre la importancia del tiempo de residencia, también llamado de permanencia, de un gas dentro de un gap de descarga de barrera de dieléctrico, para el tratamiento del dióxido de carbono CO2, el cual es un gas contaminante. Junto al CO2, se adicionó hidrógeno H2 para conformar la atmósfera de reacción de la descarga. Se estudió el comportamiento de la potencia entregada al sistema en función de la tensión de operación, utilizando alúmina y cuarzo como dieléctricos. También se estudió la conversión del CO2 en función del tiempo de residencia para tres diferentes composiciones de la mezcla CO2 + H2, para tres diferentes valores de potencia eléctrica activa suministrada al sistema y para tres diferentes valores de frecuencia de operación, utilizando alúmina como dieléctrico. El porcentaje de conversión del CO2 en las condiciones de trabajo fijadas, se incrementó al aumentar el tiempo de residencia, independientemente de la composición de la mezcla de los dos gases, de la potencia eléctrica y de la frecuencia de operación, encontrando los valores más altos para la menor cantidad de CO2 en la mezcla, para la mayor potencia suministrada y para la menor frecuencia de operación.