Broken on impact: Two competing models have been proposed for the adsorption of molecular hydrogen on platinum surfaces. Both invoke dissociation at surface defects but differ on whether hydrogen molecules diffuse along the surface before encountering a defect or adsorb only if they initially impact a defect site. Van Lent et al. studied the sticking of hydrogen molecules from a molecular beam scanned across a curved platinum single-crystal surface that varied in the density and type of defects exposed. Modeling of the results was consistent only with the second model invoking direct impact. Science , this issue p. 155
2 August 2018 in Physical Chemistry Chemical Physics
We present a combined experimental–theoretical study on structural and coverage dependences of the adsorption and desorption of molecular hydrogen on atomically flat Cu(111) and highly stepped Cu(211) surfaces.
Temperature has an important effect on the dissociative adsorption of molecular oxygen on platinum surfaces. Here, we show that if the substrate temperature is increased to 400–600 K, the total amount of oxygen loaded onto Pt(111) can be more than twice the well-established maximum coverage of 0.25 ML. While low energy electron diffraction and STM reveal a conventional p(2 × 2) structure of the topmost layer, temperature programmed desorption measurements indicate that additional oxygen is stored under the surface of platinum. Reactivity measurements show that this sub-surface oxygen layer does not lower the activity of such platinum surface towards CO oxidation. Therefore, while sub-surface oxygen layer does form under catalytically relevant temperatures on Pt(111), it has no great influence on the oxidizing ability of such surface. This sheds new light on the initial stages of platinum oxide formation, and may help bridge the understanding of catalytic oxidation of CO on Pt in ultra high vacuum and in high-pressure catalysis studies.
We present the design of a periscope-type VIS spectrometer for educational purposes that combines strong features from various earlier designs and adds new ones. Three 3D-printed pieces that hold a small thin mirror sheet, a 1/8th wedge of a DVD, and two razor blades are easily assembled and facilitate insight into its construction. A new feature is the permanent attachment of the flexible back cover of any smartphone, allowing for repeated removal and insertion of the smartphone with precision alignment for recording spectra. An optional fourth 3D-printed piece acting as a container for a PMMA UV semimicrocuvette, a white LED and a UV LED, and a 9 V battery attaches to the front. Beyond commonly applied absorption spectroscopy with similar devices, our design also allows for fluorescence spectroscopy. We report results of straightforward experiments illustrating the various uses of this less than $40 MiniSpectroscope.
25 April 2013 in The Journal of Physical Chemistry C
We have examined water desorption from Pt(111) terraces of varying width and its dependence on precoverage by deuterium (D) with temperature programmed desorption studies. We observe distinct water desorption from (100) steps and (111) terraces, with steps providing adsorption sites with a higher binding energy than terraces. Preadsorption of D at the steps causes annihilation of water stabilization at the steps, while it also causes an initial stabilization of water on the (111) terraces. When the (111) terraces also become precovered with D, this water stabilization trend reverses on all surfaces. Destabilization continues for stepped surfaces containing up to 8-atom wide (111) terraces with a (100) step type and these become hydrophobic, in contrast to surfaces with a (110) step type and with the infinite (111) terrace. Our results illustrate how surface defects and a delicate balance between intermolecular forces and the adsorption energy govern hydrophobic vs. hydrophilic behavior, and that the influence of steps on the adsorption of water on nano-structured platinum surfaces has a very long-ranged character.