Two kinds of cotton linter-based adsorbents were synthesized by grafting dimethylaminoethyl methacrylate (DMAEMA) on cotton linter via radiation grafting polymerization, followed by further quaternization (QCL) or protonation (PCL). The effect of radiation dose and monomer concentration on grafting yield was optimized. The synthesized adsorbents were characterized by Fourier transform infrared spectrometry (FT-IR), Thermogravimetric Analysis (TGA), scanning electron microscope (SEM) and X-ray photoelectron spectroscopy (XPS). The adsorption behaviors of the two adsorbents toward humic acid (HA) were investigated and discussed. pH effect studies showed that QCL was pH-independent, whereas PCL was just suitable for HA adsorption with pH < 6. The adsorption kinetics of the PCL and QCL adsorbent for HA removal were better described by pseudo-second-order kinetic mode and reached equilibrium in 40 min. The adsorption isotherms of the PCL and QCL adsorbent were well fitted with both Langmuir and Freundlich isotherm models, for which adsorption capacity reached 250 mg/g and 333 mg/g at pH 6, respectively. XPS analysis revealed the ratio of two amino group species at different pH, suggesting that the interaction mechanism of the adsorbent and HA was electrostatic adsorption.
2 March 2020 in Journal of Chemical & Engineering Data
A quaternized cotton linter fiber (QCLF) based adsorbent for removal of phosphate was prepared by grafting glycidyl methacrylate onto cotton linter and subsequent ring-opening reaction of epoxy groups and further quaternization. The adsorption behavior of the QCLF for phosphate was evaluated in a batch and column experiment. The batch experiment demonstrated that the adsorption process followed pseudo-second-order kinetics with an R2 value of 0.9967, and the Langmuir model with R2 value of 0.9952. The theoretical maximum adsorption capacity reached 152.44 mg/g. The experimental data of the fixed-bed column were well fitted with the Thomas and Yoon–Nelson models, and the adsorption capacity of phosphate at 100 mg/L and flow rate 1 mL/min reached 141.58 mg/g. The saturated QCLF could be regenerated by eluting with 1 M HCl.
Boron nitride nanosheets (BNNSs) exfoliated from hexagonal boron nitride (h-BN) show great potential in polymer-based composites due to their excellent mechanical properties, highly thermal conductivity, and insulation properties. Moreover, the structural optimization, especially the surface hydroxylation, of BNNSs is of importance to promote their reinforcements and optimize the compatibility of its polymer matrix. In this work, BNNSs were successfully attracted by oxygen radicals decomposed from di-tert-butylperoxide (TBP) induced by electron beam irradiation and then treated with piranha solution. The structural changes of BNNSs in the modification process were deeply studied, and the results demonstrate that the as-prepared covalently functionalized BNNSs possess abundant surface hydroxyl groups as well as reliable structural integrity. Of particular importance is that the yield rate of the hydroxyl groups is impressive, whereas the usage of organic peroxide and reaction time is greatly reduced due to the positive effect of the electron beam irradiation. The comparisons of PVA/BNNSs nanocomposites further indicate that the hydroxyl-functionalized BNNSs effectively promote mechanical properties and breakdown strength due to the enhanced compatibility and strong two-phase interactions between nanofillers and the polymer matrix, which further verify the application prospects of the novel route proposed in this work.