Aim: The objective of the review paper aims to explore and to provide the insight of various low-cost adsorbents prepared and used in the removal of hazardous dye pollutants from the contaminated industrial effluents. Background: The major untreated discharge from the textile industries constitutes a wide range of organic contaminants with the enhanced concentration of biological oxygen demand and chemical oxygen demand inthe water bodies. Dyes are considered as the major water contaminants and this quest the researchers to adopt various technologies to remove the hazardous dye pollutants from the aquatic environment. Dyes are the chemical compounds that tend to adhere themselves with metal or salts by covalent bond formation or complexes by mechanical retention or physical adsorption so as to impart colours to which it is being applied. Objective: Numerous treatment methodologies which have been applied to the degradation of dyes. The current study has been focused on the distinct low cost and cost-effective adsorbents used in the removal of various dye pollutants. Also, the application of nanoparticles in the removal of the hazardous dye pollutants had received great interest because of its size and high reactive nature. Methods: The treatment technologies used in the removal of dye pollutants from wastewater have been listed as adsorption, coagulation, electrocoagulation, flocculation, membrane filtration, oxidation and biological treatment. Results: The complex structure of the dyes causes a great harmful impact on the aquatic environment. Though numerous treatment technologies have been applied, adsorption has been preferred by various researchers because of its cost-effective nature. Conclusion: The various adsorbents are used in the removal of cationic, anionic and non-ionic dyes. The different types of adsorbent from agricultural waste, activated carbons, nanomaterials and biomaterials have been discussed with the advantages and limitations.
Treatment and safe disposal of tannery saline wastewater, a primary effluent stream that is generated by soaking salt-laden hides and skin is one of the major problems faced by the leather manufacturing industries. Conventional treatment methods like solar evaporation ponds and land composting are not eco-friendly as they deteriorate the ground water quality. Though, this waste stream is comprised of high concentration of dissolved proteins the presence of high salinity (1-6 % NaCl by wt) makes it non-biodegradable. Enzymatic treatment is one of the positive alternatives for management of such kind of waste streams. A novel salt-tolerant alkaline protease obtained from P.aeruginosa (isolated from tannery saline wastewater) was used for enzymatic degradation studies. The effect of various physical factors including pH, temperature, incubation time, protein source and salinity on the activity of identified protease were investigated. Kinetic parameters (Km , Vmax) were calculated for the identified alkaline protease at varying substrate concentrations. Tannery saline wastewater treated with identified salt tolerant protease showed 75 % protein removal at 6 h duration and 2 % (v/v) protease addition was found to be the optimum dosage value
Organic acids such as citric acid, itaconic acid and oxalic acid synthesised by Aspergillus niveus were used for the bioleaching of metals from waste printed circuit boards. Bioleaching of valuable metals was performed in one‐step, two‐steps and spent medium approaches using A. niveus . In the absence of waste printed circuit boards (WPCBs), the dry cell weight of A. niveus was higher when compared with the presence of WPCBs. Variations in the dry cell weight were observed for the presence of different particle sizes. The increase in itaconic acid and oxalic acid synthesis was found at a reduced particle size (60–80 mesh) and reached the maximum titre of itaconic acid (22.35 ± 0.87 mM) and oxalic acid (12.75 ± 0.54 mM) in 12 days during the two‐step bioleaching. The maximum recovery of 75.66% Zn, 73.58% Ni and 80.25% Cu from WPCBs was achieved in 15 days in two‐step leaching with particle sizes of the mesh being 60–80.