Suat Utku Ay

Prof. Suat Utku Ay

Department of Electrical and Computer Engineering, University Idaho, 875 Perimeter Drive, MS:1023 Mocsow, ID, 82844-1023, USA
orcid

Research Focus & Metrics

Academic Career Length

24Years (2003-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 August 2010
Verified
Conference Paper
Closed access
AMAli Mesgarani
Ali Mesgarani
MAMustafa N. Alam
Mustafa N. Alam
FNFan. Z. Nelson
Fan. Z. Nelson
Suat Utku AySuat Utku Ay
Suat Utku Ay
This paper presents a technique called supply boosting for designing sub-1V analog/mixed-signal circuits. Supply boosting technique (SBT) is suitable for sub-micron CMOS processes containing MOSFET transistors with threshold voltages comparable to the supply voltage. SBT is based on the idea that if current consumption of the circuit block is very low, in the order of nanoamper, supply voltage could be boosted locally to higher levels during a period that the processing of input signals is done. This technique is very suitable for very-low power clocked and continuous time circuits such as level shifters, operational amplifiers, and comparators. Design of a 10-bit supply boosted (SB) SAR ADC is presented as an example of the technique. SB-SAR ADC simulated using 0.5μm CMOS process that has high-V T NMOS and PMOS devices. Simulations show that the SB-SAR ADC achieves 0.24pJ/conv-step figure of merit (FOM) when operating ADC at 10KS/sec and 1.2V supply.

6 March 2015 in Sensors
Verified
Journal Article
Open access
PDF file
ICIsmail Cevik
Ismail Cevik
Xiwei HuangXiwei Huang
Xiwei Huang
HYHao Yu
Hao Yu
MYMei Yan
Mei Yan
Suat Utku AySuat Utku Ay
Suat Utku Ay
An ultra-low power CMOS image sensor with on-chip energy harvesting and power management capability is introduced in this paper. The photodiode pixel array can not only capture images but also harvest solar energy. As such, the CMOS image sensor chip is able to switch between imaging and harvesting modes towards self-power operation. Moreover, an on-chip maximum power point tracking (MPPT)-based power management system (PMS) is designed for the dual-mode image sensor to further improve the energy efficiency. A new isolated P-well energy harvesting and imaging (EHI) pixel with very high fill factor is introduced. Several ultra-low power design techniques such as reset and select boosting techniques have been utilized to maintain a wide pixel dynamic range. The chip was designed and fabricated in a 1.8 V, 1P6M 0.18 µm CMOS process. Total power consumption of the imager is 6.53 µW for a 96 × 96 pixel array with 1 V supply and 5 fps frame rate. Up to 30 μW of power could be generated by the new EHI pixels. The PMS is capable of providing 3× the power required during imaging mode with 50% efficiency allowing energy autonomous operation with a 72.5% duty cycle.

15 August 2010 in Analog Integrated Circuits and Signal Processing
Verified
Journal Article
Closed access
PDF file
Suat Utku AySuat Utku Ay
Suat Utku Ay

2 November 2011 in IEEE Transactions on Biomedical Circuits and Systems
Verified
Journal Article
Closed access
Suat Utku AySuat Utku Ay
Suat Utku Ay
A CMOS image sensor capable of imaging and energy harvesting on same focal plane is presented for retinal prosthesis. The energy harvesting and imaging (EHI) active pixel sensor (APS) imager was designed, fabricated, and tested in a standard 0.5 μm CMOS process. It has 54 × 50 array of 21 × 21 μm2 EHI pixels, 10-bit supply boosted (SB) SAR ADC, and charge pump circuits consuming only 14.25 μW from 1.2 V and running at 7.4 frames per second. The supply boosting technique (SBT) is used in an analog signal chain of the EHI imager. Harvested solar energy on focal plane is stored on an off-chip capacitor with the help of a charge pump circuit with better than 70% efficiency. Energy harvesting efficiency of the EHI pixel was measured at different light levels. It was 9.4% while producing 0.41 V open circuit voltage. The EHI imager delivers 3.35 μW of power was delivered to a resistive load at maximum power point operation. The measured pixel array figure of merit (FoM) was 1.32 pW/frame/pixel while imager figure of merit (iFoM) including whole chip power consumption was 696 fJ/pixel/code for the EHI imager.

28 August 2015 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
ICIsmail Cevik
Ismail Cevik
Suat Utku AySuat Utku Ay
Suat Utku Ay
A novel ultra-low power energy harvesting and imaging (EHI) type CMOS active pixel sensor (APS) imager with self-power capability is presented. The proposed EHI type CMOS APS pixel harvests one order of magnitude higher power than that of the other pixel technologies reported in the literature. It produces 46 μW of power under 57 klux illumination. The EHI imager presented has decoupled imaging and harvesting operations such that imaging related circuits are turned off while energy is harvested, and vice versa. The imager can operate on 1 V supply voltage consuming as low as 800 nW while capturing 1 frame per second (fps). Measured minimum full-chip imager FoM is 148 pJ/frame*pixel while capturing 21.2 fps. The imager contains a 64 × 45 array of 18 μm×18 μm EHI pixels. It is manufactured in a standard 2P4M/3.3 V 0.35 μm CMOS process. Ultra-low power operation is achieved by developing new imaging electronics including current reference generator, readout circuits, and SAR type, 8-bit, analog-to digital converter (ADC). A new polarity inverting charge pump circuit was developed for managing the energy harvested by the new energy harvesting pixels on the focal plane.

17 July 2020 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
MOHAMED ELMEZAYENMOHAMED ELMEZAYEN
MOHAMED ELMEZAYEN
BWBingxing Wu
Bingxing Wu
Suat Utku AySuat Utku Ay
Suat Utku Ay
Integrating type analog-to-digital converters (ADC) used in column-parallel CMOS image sensors trade conversion speed with size, power, and complexity to achieve optimal performance. A new integrating ADC architecture called single-slope look-ahead ramp (SSLAR) ADC is introduced in this paper. It utilizes a statistical approach and code-prediction methods to improve the conversion speed of standard single-slope ramp (SSR) ADC. It is shown that SSLAR ADC reduces power consumption while achieving an increased frame rate. This is achieved by the SSLAR algorithm that was optimized for column-parallel CMOS active pixel sensor (APS) imager architecture. A 10-bit SSLAR ADC was designed in a 0.5μm CMOS (2P3M) process and integrated with a column-parallel CMOS image sensor that has 200x 150 array with 15μm pixels. Measurements showed that a 6x frame rate increase can be achieved while reducing power consumption 13% with minimal impact on image quality.