The resonant characteristic of rectangular strip patch resonator (RSPR) is studied in detail, and a new dual-mode resonator based on TM100 and TM020 modes is proposed to design bandpass filters (BPFs). A two-pole BPF with two finite transmission zeros (FTZs) based on one nondegenerate dual-mode RSPR is presented and analyzed. And then, a four-pole BPF with four FTZs based on two cascaded nondegenerate dual-mode RSPRs is proposed. The two dual-mode RSPRs are connected directly by a quarter wavelength strip-line. Finally, a four-pole BPF with the center frequency of 5.8 GHz is designed, fabricated and measured. The measured insertion loss in center frequency, 1-dB bandwidth and return loss are 1.45 dB, 206 MHz and 12.85 dB, respectively. Measured Q-factor is about 315.
13 May 2024 in IEEE Antennas and Wireless Propagation Letters
In this letter, a broadband polarization rotating frequency selective surface (BPR-FSS) is reported based on antenna-filter-antenna module. In the operating frequency range of 5.76-7.12GHz, the structure can convert y-polarized incidence to x-polarization and provide a low insertion loss with a minimum of 0.1dB while x-polarized incidence is fully reflected. The relative bandwidth reaches up to 21.12%. Moreover, a novel tunable BPR-FSS (TBPR-FSS) is designed by introducing a PIN diode based on the structure of BPR-FSS, which can be regarded as a BPR-FSS or a full reflector depending on the state of the introduced diode. The corresponding equivalent circuit model is constructed to analyze its tunable mechanism in detail. Good agreements can be observed between simulation and measurement.
13 October 2022 in IEEE Antennas and Wireless Propagation Letters
In this letter, a high selectivity frequency selective surface (FSS) with three independently controllable transmission poles (TPs) is proposed by using matrix synthesis. The response with three TPs and four transmission zeros (TZs) is obtained by employing a triplet topology. The matrix synthesis method provides a theoretical analysis for coupling elements regarding to three independently controllable TPs. Also, the synthesized matrix gives a good prediction of flexile responses with allocated center frequency and bandwidth. To be verified, a finite FSS prototype with 15×15 unit cells is fabricated and tested. The measured results are mostly consistent with simulated and synthesized ones, manifesting merits of high selectivity, flexible design, and low profile.
In this paper, a novel design of high roll‐off frequency selective surface (FSS) is proposed based on a single‐layer substrate integrated waveguide (SIW) cavity. Fully canonical filtering responses with three transmission poles (TPs) and three transmission zeros (TZs) are obtained by employing transversal signal‐interference techniques (TSITs). The FSS unit cell can be regarded as a combined triple‐mode cavity consisting of one cross‐slot resonator and two SIW cavities. By using the filtering coupling matrix, the FSS can be well designed and analysed. Accordingly, to verify the design concept, a prototype is fabricated and experimented. Measured and simulated results are in good agreement, showing high performances in terms of high roll‐off and low profile.
30 May 2022 in IEEE Transactions on Instrumentation and Measurement
As the safe applications of satellite navigation face tough challenges, navigation confrontation has gradually become the focus of every country. Effective evaluation of its performance not only helps improve the core capability of the related devices as required but also largely determines the success of the related objectives and tasks. However, current research studies mainly focused on the subsystems of navigation confrontation or certain technologies in the subsystem, without aiming at its complete system, which caused an incomplete index system and inadequate evaluation methods for navigation confrontation, and the lack of the relevance and applicability between scattered research results and the final requirements (goals). Therefore, given the navigation confrontation as the evaluation object, from the principles related to performance evaluation and system construction to the testing system including testing platforms and testing methods, the property index system is constructed and the evaluation method for each performance is purposed to make up for the shortcomings of current studies. Combined with the simulations and actual tests, the quality of the proposed system and methods is verified, and the quantification of performance indices is realized as a solid theoretical and data basis for achieving the dynamic game, the optimal decision, and the maximum benefit in the future.
28 May 2025 in IEEE Antennas and Wireless Propagation Letters
This paper proposes a dual-band frequency beam scanning antenna based on a quasi-one-dimensional (QOD) spoof surface plasmon polaritons (SSPP) structure realized by ringshaped patches. The proposed antenna achieves independent and adjustable wide-angle beam steering across dual frequency bands through the simultaneous control of electromagnetic wave radiation in the fast-wave and slow-wave regions. The QOD SSPP transmission line operates in the fast-wave region at higher-order modes, allowing electromagnetic wave radiation to be achieved in the high-frequency band without additional structures. Meanwhile, the SSPP line supports slow-wave transmission, and the ring-shaped patch array also enables a second operating frequency band in the low-frequency range. An antenna prototype was fabricated, demonstrating large-angle beam scanning of 85° and 52° in dual bands (5-8 GHz and 11.5- 15.5 GHz, respectively). Additionally, the design of the ringshaped patches achieves high RF transmittance, with a measured peak of 90% across the antenna's operational frequency bands.