The degradation of methylene blue (MB) using an upgraded dielectric barrier discharge (DBD) plasma reactor was investigated in this paper. Air plasma was generated in the glass bead packed bed in the reactor, which was propagated into MB solution through a microporous diffuser plate. Microdischarge phenomenon can be observed on the interface of MB solution and the diffuser plate, where plasma active species were generated. The effects of air flow rate, initial solution concentration, initial solution pH, and initial solution conductivity on MB degradation were examined. Experimental results indicated that the proposed plasma reactor was effective for MB degradation. No obvious change in MB degradation efficiency was obtained for solution with various initial pH and conductivities, which suggested the potential of the reactor in actual wastewater treatment. The possible mechanism of the generation of plasma active species for MB degradation was proposed. In addition, the total organic carbon removal and chemical oxidation demand removal after 30 min treatment were 38.5% and 48.3%, which was higher than that obtained by ozone. The energy yield for MB degradation reached up to 9.3 g/kWh. Finally, a possible degradation pathway of MB solution was proposed.
The degradation of methylene blue (MB) using a novel dielectric barrier discharge plasma reactor coupled with activated carbon supported polyurethane foam (AC/PUF) was investigated in this paper. The plasma reactor combining a glass bead-packed bed and a microporous plate was developed. The AC/PUF provided sufficient contact area between carbon media and pollutants and hence revealed a good MB removal capacity. The effects of input voltage and initial MB solution concentration on MB degradation efficiency were examined. Kinetic study indicated that plasma and AC/PUF in the coupled system had a good synergistic effect in MB degradation. The degradation efficiency of 100 ppm MB solution could reach 97.9% with 10 min treatment in the coupled system, which was close to that obtained by plasma treatment alone for 30 min (97.5%). The COD removal in the plasma and AC/PUF coupled system (90.7%) was much higher than that obtained by plasma treatment followed by AC/PUF adsorption (58.3%). In addition, the energy yield (G50) of the coupled system was up to 38.3 g kW−1 h−1, suggesting great energy efficiency of the system. Moreover, repeated use experiments of AC/PUF showed the good utilization potential of the coupled system. Finally, a possible degradation pathway of MB was proposed.
5 December 2019 in Journal of Physics D: Applied Physics
Plasma synthesis of ammonia (NH 3 ) is a potential and sustainable pathway for nitrogen fixation. In this study, non-thermal plasma (NTP) synthesis of NH 3 was conducted in a packed-bed dielectric barrier discharge (DBD) reactor. Different catalysts, including alumina (Al 2 O 3 ), light magnesium oxide (L-MgO), heavy magnesium oxide (H-MgO), Ru/Al 2 O 3 and Ru/L-MgO, were filled in the reactor and compared for NH 3 production. Various characterization techniques were used to determine the specific surface area and pore size, surface morphology, and surface acidity of the catalysts. The effects of reaction conditions on NH 3 production were examined. Results showed that the optimal N 2 /H 2 volume ratio was 2:1 since a greater quantity of N 2 favored the generation of plasma-excited nitrogen species. The synthesized NH 3 can be adsorbed by the acid sites on Al 2 O 3 , which reduced the NH 3 yield. Higher total gas flow rate improved the NH 3 production over various catalysts, mainly due to the reduced external diffusion resistance. More plasma-excited nitrogen and hydrogen species for NH 3 synthesis were formed at higher discharge power, yet the increasing rate of NH 3 yield became slower when the discharge power was higher than 32 W. Additionally, the NH 3 desorption from the catalyst was enhanced at higher temperature, which resulted in higher NH 3 yield.
4 May 2016 in The Canadian Journal of Chemical Engineering