The emission of carbon compounds (in the form of soot) to the atmosphere has a significant impact on the environment and human health. Air pollution with combustion products, having a unique combination of physical and chemical properties, is an important component of very fine suspended dust, which is emitted from various sources related to combustion processes. The carbon compounds in aerosol form and deposited in the substrate are found all over the Earth. The paper presents results of comparative research on the content of 16 polycyclic aromatic hydrocarbons (PAH) in soot samples obtained as a result of combustion of solid fuels such as hard coal with granulation above 60 mm, coal with a grain size of 25–80 mm, coal with a grain size of 8–25 mm, pellets and dry wood. On the basis of the conducted tests, it was found that the soot obtained in the combustion of coal in different granulation contains more cytotoxic PAH in comparison to the combustion of wood pellets or dry firewood.

The one of inorganic sorbents used in water treatment technology is activated alumina. Recommended by the European Commission to remove inorganic impurities, such as arsenic, fluoride, selenium and silicates. The adsorbent is usually applied in granular form, under flow conditions. It can become...

The objective of this work was to verify the granular activated alumina (AA) sorption properties, during the process of removing copper, lead and cadmium from water, and to monitor the impact of magnetic field (MF) on the effectiveness of removing copper, lead and cadmium from water. Activated...

Biological membrane reactors or membrane bioreactors (MBRs) based on pressure separation techniques are placed among the latest and most modern methods of wastewater treatment. Currently, this method is becoming more and more popular and is being implemented in smaller and larger wastewater treatment plants (WWTPs). However, technologists, operators, and managers of small WWTPs often do not understand the MBR technology installed in their sites and need extensive professional and technological information. The aim of this study was to analyze the modernized WWTP in a small town of Wydminy, located in northeastern Poland in the Great Masurian Lakes region, where the traditional secondary settling tank was replaced by an MBR. The effectiveness of wastewater treatment before modernization and after installation of the membrane module was compared. On the basis of the conducted research, it was noted that the operation of the plant after modernization is more cost-intensive. There were additional electricity costs due to ensuring adequate pressure on the membrane. Nevertheless, the obtained results of the removal of contaminants place the plant in Wydminy in the group of the most effective Polish sewage treatment plants, as compared to the results obtained in other facilities. The MBR operation also places high demands on the exploiters, prompting them to observe even the smallest changes. The conducted research is a type of a case study, which could give the readers an understanding of the necessity of traditional WWTP modernization with MBR.

The production of thermal energy is one of the sources of environmental pollution, especially when it uses traditional fossil fuels (in particular hard and brown coal). Burning conventional fuels contributes to air pollution because of emitting gases and producing waste after the process of burning in the form of ash. The work below was aimed at determining the indirect emission of PAHs in the form of fly ash, depending on the type of fuel burned. The conducted research showed which solid fuel combustion content leaves the lowest content of PAH in the fly ash. This work contains the analysis and assessment of the content of 16 PAHs (polycyclic aromatic hydrocarbons) in fly ash from the combustion of five selected solid fuels in low-power boilers. The following fuels were chosen for the research: hard coal with granulation above 60 mm, coal with the grain size of 25–80 mm, coal with the grain size of 8–25 mm, pellets with the grain size of 6 mm, and mixed dry wood. The results of the research showed that the most frequent and most concentrated compounds were naphthalene and acenaphthylene from the PAH group. These hydrocarbons have the smallest number of rings in a molecule. It was also found that the content of the LMW (Low Molecular Weight Polycyclic Aromatic Hydrocarbons) fractions in the fly ash from the analyzed fuels in ∑PAHs exceeds 57% in the case of 6 mm pellets and in the case of the ash from wood and hard coal when the grain size >60 mm. The opposite dependence can be observed in the case of the HMW (High Molecular Weight Polycyclic Aromatic Hydrocarbons) fraction.

The emission of carbon compounds (in the form of soot) to the atmosphere has a significant impact on the environment and human health. Air pollution with combustion products, having a unique combination of physical and chemical properties, is an important component of very fine suspended dust, which is emitted from various sources related to combustion processes. The carbon compounds in the aerosol and deposited in the substrate are found all over the Earth. The paper presents results of comparative research on the content of 16 polycyclic aromatic hydrocarbons (PAHs) in soot samples obtained as a result of combustion of solid fuels such as hard coal with granulation above 60 mm, coal with a grain size of 25-80 mm, coal with a grain size of 8-25 mm, pellets and dry wood. On the basis of the conducted tests, it was found that the soot obtained in the combustion of coal in different granulation contains more cytotoxic PAHs in comparison to the combustion of wood pellets or dry firewood.