We have developed a reinforcement learning (RL) model to control the melt flow in the radio frequency (RF) top-seeded solution growth (TSSG) process for growing more uniform SiC crystals with a higher growth rate. In the study, the electromagnetic field (EM) strength is controlled by the RL model to weaken the influence of Marangoni convection. The RL model is trained through a two-dimensional (2D) numerical simulation of the TSSG process. As a result, the growth rate under the control of the RL model is improved significantly. The optimized RF-coil parameters based on the control strategy for the 2D melt flow are used in a three-dimensional (3D) numerical simulation for model validation, which predicts a higher and more uniform growth rate. It is shown that the present RL model can significantly reduce the development cost and offers a useful means of finding the optimal RF-coil parameters.
The effect of solutal Marangoni convection on flow instabilities in the presence of thermal Marangoni convection in a Si-Ge liquid bridge with different aspect ratios has been investigated by three-dimensional (3D) numerical simulations under zero gravity. We consider a half-zone model of a liquid bridge between a cold (top plane) and a hot (bottom plane) disks. The highest Si concentration is on the top of the liquid bridge. The aspect ratio () drastically affects the critical Marangoni numbers: the critical solutal Marangoni number (under small thermal Marangoni numbers ()) has the same dependence on as the critical thermal Marangoni number (under small solutal Marangoni numbers ()), i.e., it decreases with increasing . The azimuthal wavenumber of the traveling wave mode increases as decreasing , i.e., larger azimuthal wavenumbers (, and 13) appear for , and only appears when is one and larger. The oscillatory modes of the hydro waves have been extracted as the spatiotemporal structures by using dynamic mode decomposition (DMD). The present study suggests a proper parameter region of quiescent steady flow suitable for crystal growth for smaller aspect ratios of the liquid bridge.
26 September 2016 in Numerical Heat Transfer, Part B: Fundamentals
The volume-averaging continuum technique has been utilized to obtain numerical predictions for the transport phenomena occurring during the dissolution process of GaSb into InSb melt in a sandwich system. Dissolution and subsequent growth in this system are achieved by the application of a temperature gradient. The developed model was first verified for two test cases [(i) fluid/solid conjugate heat transfer and (ii) the solidification process of the binary system]. The code was then utilized to simulate the dissolution process of GaSb into InSb in the GaSb/InSb/GaSb sandwich system. The present results show that the developed volume-averaging model provides accurate predictions.