The trend in the global automotive industry is moving towards electric vehicles that do not emit exhaust gases and use eco-friendly fuel. Electric vehicles are more eco-friendly compared to internal combustion engine vehicles, as they emit less carbon dioxide and pollutants. Research and development are actively underway to produce new electric vehicle models in the rapidly growing electric car market. In this study, a 2-speed transmission for electric vehicles, applicable to 300 Nm-class electric cars, has been developed. The 2-speed transmission structure enables efficient energy use and utilizes a planetary gear set and wet multi-plate clutch, which are effective in the power transmission process. The 2-speed transmission developed through the research results of this paper has a compact structure optimized for electric vehicles. The design feasibility of the transmission was verified through performance tests of the prototype, contributing to fuel efficiency improvement and environmental enhancement.

Mega trends in the global automotive industry are environmentally friendly. As laws and regulations tighten at the government level, the automobile industry is striving to develop a drive system that can operate without using fossil fuels, instead of developing an internal combustion engine using fossil fuels. Environmentally-friendly energy is attracting attention as an alternative to solve the problems of air pollution and fossil fuel depletion. Electricity is attracting the most attention among environmentally-friendly alternative fuels. In addition, research on the development of a high-efficiency and high-reliability advanced electric automobile drive system are actively being carried out. In this study, a two-speed transmission for electric vehicles is developed using environmentally-friendly fuel. The 1st and the 2nd planetary gear modules were integrated, the ring gear and the carrier gear were shared, and the dual disc brake was used to design a mechanism for fixing each sun and shifting gear. Such a structure can improve shift energy efficiency compared to that of conventional transmissions. It was judged that the structure was suitable for an electric car using a limited power supply. Each gear was designed by calculating bending strength and surface durability.

Wheelchairs are an important means of transportation for the elderly and disabled. However, the movement of wheelchairs on long curbs and stairs is restricted. In this study, a wheelchair for climbing stairs was developed based on a mechanical transmission system that rotates the entire driving part through a link structure and an actuator to change the speed. The first mode drives the caterpillar, and the second mode drives the wheels. When driving on flat ground, it uses landing gears and wheels, and when climbing stairs, it uses the caterpillar; accordingly, a stable driving is possible. The stability of the transmission is confirmed through stress analysis. The method used in our study makes it is possible to manufacture lightweight wheelchairs because a single motor drives both the wheel and caterpillar through the transmission system.

As environmental regulations have been strengthened worldwide since the Paris Climate Agreement, the automobile industry is shifting its production paradigm to focus on eco-friendly vehicles such as electric vehicles and hydrogen-battery vehicles. Governments are banning fossil fuel vehicles by law and expanding the introduction of green vehicles. The energy efficiency of electric vehicles that use a limited power source called batteries depends on the driving environment. Applying a two-speed transmission to an electric vehicle can optimize average speed and performance efficiency at low speeds, and achieve maximum speed with minimal torque at high speeds. In this study, a two-speed transmission for an electric vehicle has been developed, to be used in a compact electric vehicle. This utilizes a planetary gear of a total of three pairs, made of a single module which was intended to enable two-speed. The ring gear was removed, and the carrier was used in common. When shifting, the energy used for the speed change is small, due to the use of the simple method of fixing the sun gear of each stage. Each gear was designed by calculating bending strength and surface durability, using JGMA standards, to secure stability. The safety factor of the gears used in the transmission is as follows: all gears have been verified for safety with a bending strength of 1.2 or higher and a surface pressure strength of 1.1 or higher. The design validity of the transmission was verified by calculating the gear meshing ratio and the reference efficiency of the gear. The transmission to be developed through the research results of this paper has a simple and compact structure optimized for electric vehicles, and has reduced shift shock. In addition, energy can be used more efficiently, which will help improve fuel economy and increase drive range.