When performing speaker diarization on recordings from meetings, multiple microphones of different qualities are usually available and distributed around the meeting room. Although several approaches have been proposed in recent years to take advantage of multiple microphones, they are either too computationally expensive and not easily scalable or they cannot outperform the simpler case of using the best single microphone. In this paper, the use of classic acoustic beamforming techniques is proposed together with several novel algorithms to create a complete frontend for speaker diarization in the meeting room domain. New techniques we are presenting include blind reference-channel selection, two-step time delay of arrival (TDOA) Viterbi postprocessing, and a dynamic output signal weighting algorithm, together with using such TDOA values in the diarization to complement the acoustic information. Tests on speaker diarization show a 25% relative improvement on the test set compared to using a single most centrally located microphone. Additional experimental results show improvements using these techniques in a speech recognition task.
Restricted Boltzmann Machines (RBMs) have shown success in both the front-end and backend of speaker verification systems. In this paper, we propose applying RBMs to the front-end for the tasks of speaker clustering and speaker tracking in TV broadcast shows. RBMs are trained to transform utterances into a vector based representation. Because of the lack of data for a test speaker, we propose RBM adaptation to a global model. First, the global model—which is referred to as universal RBM—is trained with all the available background data. Then an adapted RBM model is trained with the data of each test speaker. The visible to hidden weight matrices of the adapted models are concatenated along with the bias vectors and are whitened to generate the vector representation of speakers. These vectors, referred to as RBM vectors, were shown to preserve speaker-specific information and are used in the tasks of speaker clustering and speaker tracking. The evaluation was performed on the audio recordings of Catalan TV Broadcast shows. The experimental results show that our proposed speaker clustering system gained up to 12% relative improvement, in terms of Equal Impurity (EI), over the baseline system. On the other hand, in the task of speaker tracking, our system has a relative improvement of 11% and 7% compared to the baseline system using cosine and Probabilistic Linear Discriminant Analysis (PLDA) scoring, respectively.
A new method to detect words that are likely to be confused by speech recognition systems is presented in this letter. A new dissimilarity measure between two words is calculated in two steps. First, the phonetic transcriptions of the words are aligned using only phonetic information. Two kinds of alignments are used: either with or without insertions and deletions. Second, the dissimilarity measure is calculated on the basis of the resulting alignment and acoustic information obtained from the hidden Markov models of the phones. In a classical false acceptance/false rejection framework, the equal error rate was measured to be less than 5%.
This paper addresses the problem of three-dimensional speaker orientation estimation in a smart-room environment equipped with microphone arrays. A Bayesian approach is proposed to jointly track the location and orientation of an active speaker. The main motivation is that the knowledge of the speaker orientation may yield an increased localization performance and vice versa. Assuming that the sound produced by the speaker is originated from his mouth, the center of the head is deduced based on the estimated head orientation. Moreover, the elevation angle of the head of the speaker can be partly inferred from the fast vertical movements of the computed mouth location. In order to test the performance of the proposed algorithm, a new multimodal dataset has been recorded for this purpose, where the corresponding 3D orientation angles are acquired by an inertial measurement unit (IMU) provided by accelerometers, magnetometers and gyroscopes in the three-axes. The proposed joint algorithm outperforms a two-step approach in terms of localization and orientation angle precision assessing the superiority of the joint approach.