Pressure distributions for the uniform glottis were obtained with a static physical model (M5). Glottal diameters of d = 0.005, 0.0075, 0.01, 0.02, 0.04, 0.08, 0.16, and 0.32 cm were used with a range of phonatory transglottal pressures. At each pressure and diameter, entrance loss and exit coefficients were determined. In general, both coefficients decreased in value as the transglottal pressure or the diameter increased. Entrance loss coefficients ranged from 0.69 to 17.6. Use of these coefficients with the measured flow rates in straightforward equations accurately reproduced the pressure distributions within the glottis and along the inferior vocal fold surface.
1 September 2011 in The Journal of the Acoustical Society of America
In an important paper on the physics of small amplitude oscillations, Titze showed that the essence of the vertical phase difference, which allows energy to be transferred from the flowing air to the motion of the vocal folds, could be captured in a surface wave model, and he derived a formula for the phonation threshold pressure with an explicit dependence on the geometrical and biomechanical properties of the vocal folds. The formula inspired a series of experiments [e.g., R. Chan and I. Titze, J. Acoust. Soc. Am 119, 2351–2362 (2006)]. Although the experiments support many aspects of Titze’s formula, including a linear dependence on the glottal half-width, the behavior of the experiments at the smallest values of this parameter is not consistent with the formula. It is shown that a key element for removing this discrepancy lies in a careful examination of the properties of the entrance loss coefficient. In particular, measurements of the entrance loss coefficient at small widths done with a physical model of the glottis (M5) show that this coefficient varies inversely with the glottal width. A numerical solution of the time-dependent equations of the surface wave model shows that adding a supraglottal vocal tract lowers the phonation threshold pressure by an amount approximately consistent with Chan and Titze’s experiments.
In voice research, analytically-based models are efficient tools to investigate the basic physical mechanisms of phonation. Calculations based on lumped element models describe the effects of the air in the vocal tract upon threshold pressure (Pth) by its inertance. The latter depends on the geometrical boundary conditions prescribed by the vocal tract length (directly) and its cross-sectional area (inversely). Using Titze’s surface wave model (SWM) to account for the properties of the vocal folds, the influence of the vocal tract inertia is examined by two sets of calculations in combination with experiments that apply silicone-based vocal folds. In the first set, a vocal tract is constructed whose cross-sectional area is adjustable from 2.7 cm2 to 11.7 cm2. In the second set, the length of the vocal tract is varied from 4.0 cm to 59.0 cm. For both sets, the pressure and frequency data are collected and compared with calculations based on the SWM. In most cases, the measurements support the calculations; hence, the model is suited to describe and predict basic mechanisms of phonation and the inertial effects caused by a vocal tract.
1 September 2014 in The Journal of the Acoustical Society of America
Pressure distributions were obtained for 5°, 10°, and 20° convergent angles with a static physical model (M5) of the glottis. Measurements were made for minimal glottal diameters from d = 0.005–0.32 cm with a range of transglottal pressures of interest for phonation. Entrance loss coefficients were calculated at the glottal entrance for each minimal diameter and transglottal pressure to measure how far the flows in this region deviate from Bernoulli flow. Exit coefficients were also calculated to determine the presence and magnitude of pressure recovery near the glottal exit. The entrance loss coefficients for the three convergent angles vary from values near 2.3–3.4 for d = 0.005 cm to values near 0.6 for d = 0.32 cm. These coefficients extend the tables of entrance loss and exit coefficients obtained for the uniform glottis according to Fulcher, Scherer, and Powell [J. Acoust. Soc. Am. 129, 1548–1553 (2011)].
1 October 2012 in The Journal of the Acoustical Society of America
Ishizaka and Flanagan's classic two-mass model of vocal fold motion is applied to small oscillations where the equations become linear and the aerodynamic driving force is described by an effective stiffness. The solution of these equations includes an analytic formula for the two eigenfrequencies; this shows that conjugate imaginary parts of the frequencies emerge beyond eigenvalue synchronization and that one of the imaginary parts becomes zero at a pressure signaling the instability associated with the onset of threshold. Using recent measurements by Fulcher et al. of intraglottal pressure distributions [J. Acoust. Soc. Am. 129, 1548-1553 (2011).] to inform the behavior of the entrance loss coefficients, an analytic formula for threshold pressure is derived. It fits most of the measurements Chan and Titze reported for their 2006 physical model of the vocal fold mucosa. Two sectors of the mass-stiffness parameter space are used to produce these fits. One is based on a rescaling of the typical glottal parameters of the original Ishizaka and Flanagan work. The second requires setting two of the spring constants equal and should be closer to the experimental conditions. In both cases, values of the elastic shear modulus are calculated from the spring constants.