A surface plasmon polariton detector is demonstrated at infra-red wavelengths. The device consists of a metal stripe on silicon forming a Schottky contact thereon and supporting surface a plasmon polariton mode that is strongly confined and localised to the metal–semiconductor interface. Detection of optical radiation below the bandgap of silicon (at infrared wavelengths) occurs through internal photoemission. Responsivities of 0.38 and 1.04 mA/W were measured via end-fire coupling to a tapered optical fibre, at room temperature and at a wavelength of 1280 nm, for gold and aluminium stripes on n-type silicon, respectively. The device can be integrated with other structures used in nano-plasmonics, nano-photonics or silicon-based photonics, and it holds promise for short-reach optical interconnects and power monitoring applications.
Straight long-range surface plasmon waveguides are demonstrated as biosensors for the detection of cells, proteins and changes in the bulk refractive index of solutions. The sensors consist of 5 μm wide 22 nm thick Au stripes embedded in polymer (CYTOPTM) with microfluidic channels etched into the top cladding. Bulk sensing is demonstrated by sequentially injecting six solutions of different refractive indices in 2 × 10−3 RIU increments; such index steps were detected with a signal-to-noise ratio of ~1000. Selective capture of cells is demonstrated using Au waveguides functionalized with antibodies against blood group A, and red blood cells of group A and O in buffer as positive and negative analyte. Bovine serum albumin in buffer was used to demonstrate protein sensing. A monolayer of bovine serum albumin physisorbed on a carboxyl-terminated self-assembled monolayer on Au was detected with a signal-to-noise ratio of ~300. Overall, the biosensor demonstrated a good capability for detecting bulk changes in solution and for sensing analyte over a very wide range of mass (from cells to proteins). The biosensors are compact, inexpensive to fabricate, and may find use over a wide range of cost-sensitive sensing and detection applications.
Long range surface plasmon-polariton waveguides and devices suitable for biosensing were fabricated and characterized physically and optically. The structures consist of thin (∼35 nm) patterned Au stripes embedded in thick Cytop claddings (∼8 μm each). Portions of Au stripes were exposed by patterning and etching though the top Cytop cladding using an O2 plasma etch. The etched Cytop cavities act as microfluidic channels to contain and direct the sensing fluid. Intermediate process steps were verified through physical characterization as were fully fabricated structures. Optical testing was performed on Cytop-embedded structures and on channel-filled (with sensing fluid) structures. The structures were excited through end-fire coupling to optical fibers.
Single-mode surface plasmon distributed feedback (DFB) lasers are realized in the near infrared using a two-dimensional non-uniform long-range surface plasmon polariton structure. The surface plasmon mode is excited onto a 20 nm-thick, 1 μm-wide metal stripe (Ag or Au) on a silica substrate, where the stripe is stepped in width periodically, forming a 1st order Bragg grating. Optical gain is provided by optically pumping a 450 nm-thick IR-140 doped PMMA layer as the top cladding, which covers the entire length of the Bragg grating, thus creating a DFB laser. Single-mode lasing peaks of very narrow linewidth were observed for Ag and Au DFBs near 882 nm at room temperature. The narrow linewidths are explained by the low spontaneous emission rate into the surface plasmon lasing mode as well as the high quality factor of the DFB structure. The lasing emission is exclusively TM polarized. Kinks in light–light curves accompanied by spectrum narrowing were observed, from which threshold pump power densities can be clearly identified (0.78 MW cm−2 and 1.04 MW cm−2 for Ag and Au DFB lasers, respectively). The Schawlow–Townes linewidth for our Ag and Au DFB lasers is estimated and very narrow linewidths are predicted for the lasers. The lasers are suitable as inexpensive, recyclable and highly coherent sources of surface plasmons, or for integration with other surface plasmon elements of similar structure.