Changing environmental conditions and measured noises often affect the dynamic responses of structures and can obscure subtle changes in the vibration characteristics caused by damage. To address this issue, a new method for classifying damage in offshore structures under varying environmental conditions and measured noises is proposed using linear discrimination analysis (LDA). Two sets of data on dynamic characteristics, one from healthy structures and the other from unknown testing structures, are used to determine the optimal projection vector. This vector is perpendicular to the discriminant hyperplane and is used for damage classification. The damage‐sensitive features are extracted by projecting both sets of data onto this vector. These features are then used with the hypothesis test technique to determine the condition state of the testing structure. Numerical studies on offshore wind turbine structures and experimental validations of a deep‐sea mining system are being conducted to evaluate the effectiveness of the proposed approach. The study also examines the impact of mode combinations, measured noises and samples on the performance of the approach. The results indicate that the proposed approach can accurately assess the structural health state even in the presence of environmental changes and noise contamination, even with limited samples. The promising performance of the approach will facilitate the establishment of an online structural monitoring system to ensure the safety of offshore structures.
1 January 2021 in International Journal of Naval Architecture and Ocean Engineering
A vortex-induced vibration (VIV) experiment on a standing variable-tension deepsea riser was conducted to investigate the applicability and sensitivity of Bare Fiber Bragg Grating (BFBG) sensor technology for testing deepsea riser vibrations. The dominant frequencies, dimensionless displacements, in-line and cross-flow couplings of the riser VIV under different top tensions were observed through wavelet transform and modal decomposition. The result indicated that, excited by the same external flow velocities, the cross-flow and in-line dominant frequencies of the riser both decreased with increasing top tension. In terms of displacement responses, increasing top tension caused the root mean square (RMS) displacement to decrease and the vibration amplitude to reduce. In terms of cross-flow and in-line coupling, the closer a location is to the ends of the riser, the smaller the trajectory is and the more standard the “8” becomes. During top tension increases, there exists a “lag” in the time when the riser’s vibration trajectory becomes an “8”. The Slalom Surround Installation approach can effectively prevent the local breakage of the optical fiber string. BFBG sensor technology can give an accurate presentation of the displacement time history, vibration amplitude and frequency of the riser, provides a clear picture of how the riser’s mode and VIV evolve as a function of flow velocity.
Prediction of the spatial configuration of the umbilical cable during deep-sea mining in-situ tests is of great significance because dynamic change may cause the umbilical cable to touch the ground or overturn the mining vehicle. In the present paper, a real-time prediction method for the dynamic spatial configuration of the umbilical cable during the deep-sea mining process is proposed. At first, the environmental information, position and motion of the vessel–umbilical cable–mining system were collected by sensors arranged at different locations. Then, the data were converted and transformed to the local vessel coordinate system. After that, the commercial software OrcaFlex was employed to conduct real-time simulation, in which the spatial configuration of the umbilical cable was predicted by the lumped mass method. Furthermore, the proposed real-time simulation method was employed in a sea trial test of deep-sea mining in an area with a water depth of 1100 m. Comparing the prediction results with the trajectory of the USBL beacon obtained from the monitoring data, the maximum distance of some specific points was close to 5 m, and most of them were less than 3 m. Meanwhile, it could also give the dynamic responses of the deep-sea mining system. For example, the maximum top tension of the umbilical cable was less than 15 kN, which could be used to evaluate the health condition of the system. During the sea trial test, the proposed method played an important role in ensuring the safety of the umbilical cable during wide-range movement of the mining vehicle. With characteristics of good real-time performance, accurate prediction, high reliability and stability, the proposed method could enhance the confidence of engineers for on-site operation as a powerful digital tool for visualization of the subsea working state.