This paper proposes to use a correlator-level global positioning system (GPS) line-of-sight/multipath/non-line-of-sight (LOS/MP/NLOS) signal reception classifier to improve positioning performance in an urban environment. Conventional LOS/MP/NLOS classifiers, referred to as national marine electronics association (NMEA)-level and receiver independent exchange format (RINEX)-level classifiers, are usually performed using attributes extracted from basic observables or measurements such as received signal strength, satellite elevation angle, code pseudorange, etc. The NMEA/RINEX-level classification rate is limited because the complex signal propagation in urban environment is not fully manifested in these end attributes. In this paper, LOS/MP/NLOS features were extracted at the baseband signal processing stage. Multicorrelator is implemented in a GPS software-defined receiver (SDR) and exploited to generate features from the autocorrelation function (ACF). A robust LOS/MP/NLOS classifier using a supervised machine learning algorithm, support vector machine (SVM), is then trained. It is also proposed that the Skymask and code pseudorange double difference observable are used to label the real signal type. Raw GPS intermediate frequency data were collected in urban areas in Hong Kong and were postprocessed using a self-developed SDR, which can easily output correlator-level LOS/MP/NLOS features. The SDR measurements were saved in the file with the format of NMEA and RINEX. A fair comparison among NMEA-, RINEX-, and correlator-level classifiers was then carried out on a common ground. Results show that the correlator-level classifier improves the metric of F1 score by about 25% over the conventional NMEA- and RINEX-level classifiers for testing data collected at different places to that of training data. In addition to this finding, correlator-level classifier is found to be more feasible in practical applications due to its less dependency on surrounding scenarios compared with the NMEA/RINEX-level classifiers.

Performing precise positioning is still challenging for autonomous driving. Global navigation satellite system (GNSS) performance can be significantly degraded due to the non-line-of-sight (NLOS) reception. Recently, the studies of 3D building model aided (3DMA) GNSS positioning show promising positioning improvements in urban canyons. In this study, the benefits of 3DMA GNSS are further extended to the GNSS/inertial navigation system (INS) integration system. Based on the shadow matching solution and scoring information of candidate positions, two methods are proposed to better classify the line-of-sight (LOS) and NLOS satellite measurements. Aided by the satellite visibility information, the NLOS-induced pseudorange measurement error can be mitigated before fusing GNSS with the INS in the loosely-coupled or tightly-coupled integration system. Both the proposed satellite visibility estimation methods achieve over 80% LOS/NLOS classification accuracy for most of the scenarios in the urban area, which are at least 10% improvement over the carrier-to-noise ratio (C/N_0)-based method. By further extending the satellite visibility estimation to exclude NLOS measurements and adjust the measurement noise covariance, the proposed 3DMA GNSS/INS tightly-coupled integrated positioning achieves nearly a factor of 3 improvements comparing to the conventional GNSS/INS integration method during the vehicular experiment in the urban canyon.

Spoofing can seriously threaten the use of the Global Positioning System (GPS) in critical applications such as positioning and navigation of autonomous vehicles. Research into spoofing generation will contribute to assessment of the threat of possible spoofing attacks and help in the development of anti-spoofing methods. However, the recent commercial off-the-shelf (COTS) spoofing generators are expensive and the technology implementation is complicated. To address the above problem and promote the GPS safety-critical applications, a spoofing generator using a vector tracking-based software-defined receiver is proposed in this contribution. The spoofing generator aims to modify the raw signals by cancelling the actual signal component and adding the spoofing signal component. The connections between the spreading code and carrier, and the states of the victim receiver are established through vector tracking. The actual signal can be predicted effectively, and the spoofing signal will be generated with the spoofing trajectory at the same time. The experimental test results show that the spoofing attack signal can effectively mislead the victim receiver to the designed trajectory. Neither the tracking channels nor the positioning observations have abnormal changes during this processing period. The recent anti-spoofing methods cannot detect this internal spoofing easily. The proposed spoofing generator can cover all open-sky satellites with a high quality of concealment. With the superiority of programmability and diversity, it is believed that the proposed method based on an open source software-defined receiver has a great value for anti-spoofing research of different GNSS signals.

Accurate localization of road agents (GNSS receivers) is the basis of intelligent transportation systems, which is still difficult to achieve for GNSS positioning in urban areas due to the signal interferences from buildings. Various collaborative positioning techniques were recently developed to improve the positioning performance by the aid from neighboring agents. However, it is still challenging to study their performances comprehensively. The GNSS measurement error behavior is complicated in urban areas and unable to be represented by naive models. On the other hand, real experiments requiring numbers of devices are difficult to conduct, especially for a large-scale test. Therefore, a GNSS realistic urban measurement simulator is developed to provide measurements for collaborative positioning studies. The proposed simulator employs a ray-tracing technique searching for all possible interferences in the urban area. Then, it categorizes them into direct, reflected, diffracted, and multipath signal to simulate the pseudorange, $C/N_0$, and Doppler shift measurements correspondingly. The performance of the proposed simulator is validated through real experimental comparisons with different scenarios based on commercial-grade receivers. The proposed simulator is also applied with different positioning algorithms, which verifies it is sophisticated enough for the collaborative positioning studies in the urban area.