Piezoelectric energy harvesting from bridge vibrations has attracted many researchers not because it provides a clean and autonomous solution to power portable electronic devices, in addition, it helps in making a smart city. This paper focuses on energy harvesting from low-frequency bridge vibrations which includes vibrations measurements from a city flyover and laboratory experiment using traditional rectifier circuit at low frequency and small amplitude vibrations for storage. The typical practical issues have been addressed associated with PEH from bridge vibrations and electrical circuitry.
Piezoelectric materials have secured a significant place in the field of structural health monitoring (SHM) and energy harvesting over the past two decades. These materials are available in several forms and configurations, the efficacy of especially curved configurations is still unexplored. This article investigates, both experimentally and numerically, the potency of the curved configuration of the piezo transducers over the straight configuration when embedded in reinforced concrete (RC) structures for energy harvesting and SHM. The study consists of the comparative analysis of (a) open-circuit voltage generated across the piezo transducers; (b) the power developed under the impedance matching conditions; and (c) the potential of power storage into capacitors for both configurations. The article also experimentally examines the hitherto unexplored damage detection capability of the curved piezo transducers by the electro-mechanical impedance (EMI) technique. Results clearly demonstrate that curved piezo transducers exhibit better performance in comparison to straight configurations for both structural health monitoring and energy harvesting. A finite element (FE) analysis is also performed through a 3-D model of the real-life-sized RC beam with straight and curved piezo transducers embedded inside to evaluate the various parameters such as the angle of bend, the thickness, the number of elements and the position of placement of the curved transducers for energy harvesting. The FE simulations reveal an optimum range of the angle of bend as 130 to 160 degrees. There is a substantial impact of the increase in thickness of the transducers for energy harvesting in terms of its open-circuit voltage. The numerical analysis also suggests that the optimum position of placement of the piezo transducers is towards the top or bottom of the beam cross-section. The outcomes of the experimental and numerical investigations are very pivotal for the implementation of curved piezo transducers in real-life RC structures for improved energy harvesting and structural health monitoring.
Micro cantilevers are an important component of smart sensors as they detect the stress on surfaces caused by various physical/ chemical or biological parameters. The proper design of the cantilever dimension helps to achieve optimum sensitivity of sensor. This work presents the design simulations of Si cantilever beam using Finite element method. The design is implemented by fabrication of a pair of cantilevers on a single trench. Deep Reactive-Ion Etching (DRIE) was employed to release the Si cantilever from bulk silicon. The released structure was characterized by using Laser Doppler Vibrometer (LDV). The Eigen frequency of the cantilever measured by LDV is found to be similar to the designed specifications. The design and fabrication aspects have been discussed in the paper along with analysis of the Eigen frequency achieved.
The applications of wireless sensor nodes (WSNs) are rapidly growing in civil infrastructures, yet constrained by batteries with the short lifespan. Providing an alternative power source will undoubtedly expand the application for WSNs and other technologies such as energy harvesting. This paper presents a basic field study conducted on a city flyover to explore the possibility of piezoelectric energy harvesting from bridge vibrations. A piezoelectric energy harvester based on Micro Fiber Composite (MFC) has fabricated. The maximum voltage and average power generated by stainless steel PEH with surface bonded MFC patch was found to be 1.34 V and 0.784 μW respectively. Finally, the practical application of energy harvested achieved by lighting an LED with vibration energy.