An evaluation is presented of the practical usage of the Herschel-Bulkley viscosity model for drilling fluids. If data from automatic viscosity measurements exist, the parameters should be selected from relevant shear rate ranges to be applicable. To be able to be used properly, viscosity measurements must be measured with a sufficient accuracy. It is shown that a manual reading of standard viscometers may yield insufficient accuracy. It is also shown that the use of yield point/plastic viscosity (YP/PV) as measured using API or ISO standards normally provide inaccurate viscosity parameters. The use of the Herschel-Bulkley model using dimensionless shear rates is more suitable than the traditional way of writing this model when the scope is to compare different drilling fluids. This approach makes it also easier to make correlations with thermodynamic quantities like pressure and temperature or chemical or mineralogical compositions of the drilling fluid.
The increasing necessity of challenging wellbore structures and drilling optimization for improved hole cuttings cleaning has been growing along time. As a result, operator companies have been researching and applying different hole cleaning techniques. Some of these are applied as traditional rules of thumb but are not always suitable for the new and up-coming challenges. This may result in inefficient hole cleaning, non-productive times, pipe stocking and low rate of penetration (ROP), among other problems. Here are presented some results and improvements for hole cleaning optimization obtained by the different research groups. The different authors mainly focus on specific cuttings transport parameters and sometimes combination of some of them. For this reason, there has not been a study that takes into account all of the different factors at the same time to accurately predict the cuttings bed height, formation and erosion, critical fluid velocity and properties and other key parameters. Consequently, there is a lack of understanding about the relation between different factors, such as the cohesiveness of the drilled cuttings with the different interstitial drilling fluids within the cuttings-bed. This relation can be analyzed establishing a wet-granular approach to obtain more efficient cuttings transport mechanism in challenging conditions.
During drilling operations, effective displacement of fluids can provide high-quality cementing jobs, ensuring zonal isolation and strong bonding of cement with casing and formation. Poor cement placements due to incomplete mud removal can potentially lead to multiple critical operational problems and serious environmental hazards. Therefore, efficient mud removal and displacement of one fluid by another one is a crucial task that should be designed and optimized properly to guarantee the zonal isolation and integrity of the cement sheath. The present work provides an overview of the research performed on mud removal and cement placement to help the industry achieve better cementing jobs. An extensive number of investigations have been conducted in order to find some key techniques for minimizing the cement contamination and obtaining maximum displacement efficiency. Yet, even after implementing those techniques, the industry happens to encounter poor cementing jobs. The present review aims to assist with evaluating the current theories, methodologies, and practical techniques, in order to possibly identify the research gaps and facilitate the way for further improvements.
28 April 2014 in Journal of Energy Resources Technology