JIMMY A. MORALES-MORALES

Dr. JIMMY A. MORALES-MORALES


Research Focus & Metrics

Academic Career Length

20Years (2007-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 April 2014 in Environmental Chemistry
Verified
Journal Article
Closed access
PDF file
MVMario Villalobos
Mario Villalobos
MCManuel Carrillo-Cárdenas
Manuel Carrillo-Cárdenas
RGRichard Gibson
Richard Gibson
NLN. Ruth López-Santiago
N. Ruth López-Santiago
JMJIMMY A. MORALES-MORALES
JIMMY A. MORALES-MORALES
Environmental context: Sorption and oxidation reactions at mineral surfaces can substantially influence the mobility and toxicity of environmental contaminants. An understanding of the factors that control these reactions is crucial for predicting the fate of contaminant species. We investigate the reactivity of manganese oxides towards polycyclic aromatic hydrocarbons, persistent organic compounds of environmental concern. Birnessites are ubiquitous components of natural systems and may exert a significant influence on the mobility and toxicity of different types of contaminants, including organic species. Their small particle sizes and internal structure provide them with high sorption capacities and oxidising abilities for redox sensitive species. In the present work, the interactions of two MnIV birnessites (d-MnO2 and acid birnessite) of different particle sizes and layer vacancy contents were investigated with four hydrophobic polycyclic aromatic hydrocarbons (PAHs) of three and four rings. Fluorene and anthracene were oxidised to produce the corresponding and less toxic quinones by both birnessites, but at a higher rate and extent by d-MnO2. Phenanthrene and fluoranthene only adsorbed to d-MnO2 but not to acid birnessite. The higher reactivity of d-MnO2 is only partly explained by its higher specific surface area (114 v. 39 m2 g–1), i.e. by its smaller particle size. The repulsive effect of water molecules from hydrated cations sorbed on layer vacant sites is most likely decisive, because acid birnessite shows a considerably larger content of these vacancies. The results presented provide a fundamental understanding of the potential influence of birnessite minerals on the attenuation of low molecular weight PAHs in environments with low organic matter content, such as deep aquifers.

25 February 2022 in Molecules
Verified
Journal Article
Open access
PDF file
CGClaudia Granja Granja
Claudia Granja Granja
DSDaniel Gerardo Silgado-Cortázar
Daniel Gerardo Silgado-Cortázar
JMJIMMY A. MORALES-MORALES
JIMMY A. MORALES-MORALES
This study used substituted barium hexaferrites, which were previously prepared and reported by the authors, to detect acetaminophen by the modification of a conventional glassy carbon electrode (GCE), which led to promising results. The synthesis of this electrode-modifying material was conducted using a citrate sol gel process. A test synthesis using glycerin and propylene glycol revealed that glycerin produced a better result, while less positive anodic potential values were associated with the electrooxidation of N-acetyl-p-aminophenol (NAP). Excellent electroactivity was exhibited by the cobalt-substituted barium-hexaferrite-nanomaterial-modified electrode. A good linear relationship between the concentration and the current response of acetaminophen (paracetamol) was obtained with a detection limit of (0.255 ± 0.005) µM for the Ba1.0Co1.22Fe11.41O18.11 GCE, (0.577 ± 0.007) µM for the Ba1.14Cu0.82Fe11.65O18.02 GCE, and (0.595 ± 0.008) µM for the bare GCE. The levels of NAP in a real sample of urine were quantitatively analyzed using the proposed method, with recovery ranges from 96.6% to 101.0% and 93.9% to 98.4% for the modified electrode with Cobalt-substituted barium hexaferrites (CoFM) and Copper-substituted barium hexaferrites (CuFM), respectively. These results confirm the high electrochemical activity of Ba1.0Co1.22Fe11.41O18.11 nanoparticles and thus their potential for use in the development of sensing devices for substances of pharmaceutical interest, such as acetaminophen (NAP).

23 August 2007 in The Journal of Physical Chemistry A
Verified
Journal Article
Closed access
JMJIMMY A. MORALES-MORALES
JIMMY A. MORALES-MORALES
CFCarlos Frontana
Carlos Frontana
MAMartha Aguilar-Martínez
Martha Aguilar-Martínez
JBJosé Antonio Bautista-Martínez
José Antonio Bautista-Martínez
FGFelipe J. González
Felipe J. González
IGIgnacio González£
Ignacio González£

23 November 2023 in Biosensors
Verified
Journal Article
Open access
PDF file
JAJosé Guillermo Alfonso-González
José Guillermo Alfonso-González
CGClaudia Granja Granja
Claudia Granja Granja
JMJIMMY A. MORALES-MORALES
JIMMY A. MORALES-MORALES
ADAndres Dector
Andres Dector
This work devised a simple glycerol-assisted synthesis of a low-Cu2+-doped CoFe2O4 and the electrochemical detection of acetaminophen (AC). During the synthesis, several polyalcohols were tested, indicating the efficiency of glycerin as a cosolvent, aiding in the creation of electrode-modifier nanomaterials. A duration of standing time (eight hours) before calcination produces a decrease in the secondary phase of hematite. The synthesized material was used as an electrode material in the detection of AC. In acidic conditions (pH 2.5), the limit of detection (LOD) was 99.4 nM, while the limit of quantification (LOQ) was found to be (331 nM). The relative standard deviation (RSD), 3.31%, was computed. The enhanced electrocatalytic activity of a low-Cu2+-doped CoFe2O4-modified electrode Cu0.13Co0.87Fe2O4/GCE corresponds extremely well with its resistance Rct, which was determined using the electrochemical impedance spectroscopy (EIS) technique and defined its electron transfer capacity. The possibility of a low-Cu2+-doped CoFe2O4 for the electrochemical sensing of AC in human urine samples was studied. The recovery rates ranging from 96.5 to 101.0% were obtained. These findings suggested that the Cu0.13Co0.87Fe2O4/GCE sensor has outstanding practicability and could be utilized to detect AC content in real complex biological samples.

1 November 2024 in Journal of Renewable and Sustainable Energy
Verified
Journal Article
Closed access
IEIrma Lucia Vera Estrada
Irma Lucia Vera Estrada
ADAndres Dector
Andres Dector
VOVíctor M Ovando-Medina
Víctor M Ovando-Medina
HMHugo Martínez-Gutiérrez
Hugo Martínez-Gutiérrez
ZEZulma Flor Estrella-Chavero
Zulma Flor Estrella-Chavero
JMJIMMY A. MORALES-MORALES
JIMMY A. MORALES-MORALES
This work presents, for the first time, power generation using diabetic urine as fuel. The energy conversion is achieved through a paper-based microfluidic fuel cell. Urine has recently gained attention as a source of novel biomarkers for early disease detection, making the use of diabetic urine as fuel particularly relevant to the development of autonomous portable medical devices. A key challenge in using diabetic urine as fuel lies in the fact that it contains various molecules and compounds that can block or poison the fuel cell's electrodes. This study introduces a selective catalyst of ZnO and nickel-based particles that oxidize the urea in human urine. Different concentrations of Ni (3%, 6%, and 9%) were evaluated to optimize catalyst activity. The best performance of the diabetic urine-microfluidic fuel cell was achieved with the ZnO-Ni at 3%, yielding a maximum voltage of 0.89 V, a maximum current density of 1.18 mA cm−2, and a maximum power density of 1.26 mW cm−2. These results demonstrate the potential for enhancing point-of-care devices through paper-based microfluidic fuel cell stacks.

24 January 2017 in Journal of Physics: Conference Series
Verified
Conference Paper
Open access
PDF file
JRJ Realpe-Jaramillo
J Realpe-Jaramillo
JMJIMMY A. MORALES-MORALES
JIMMY A. MORALES-MORALES
JGJ A González-Sánchez
J A González-Sánchez
RCR Cabanzo
R Cabanzo
EME Mejía-Ospino
E Mejía-Ospino
JPJhonatan Rodriguez Pereira
Jhonatan Rodriguez Pereira
Bioactive hydroxyapatite (HA) coatings were fabricated by a precipitation, sol-gel and dip-coating method. The effects of the aging time and the base used to adjust pH and substrate materials on the phases and microstructures of HA coatings were studied by field emission scanning electron microscopy FESEM, energy dispersive spectroscopy EDS, X-ray photoelectron spectroscopy XPS, and the vibrations of the phosphate groups were determined by Raman spectroscopy. The results showed that all the films were composed of the phases of TiO2 and HA. With coated titanium substrate with TiO2, the crystallinity of the HA coating increases, the structure became more compact and the Ca/P ratio increased because of the loss of P in the films. The addition of sodium hydroxide (adjusting the pH level to about 10) can increase the HA content in the coating. XPS and EDS results for steel substrate and titanium showed poor calcium content as obtained with a Ca/P ratio of 1.38 and 1.58, respectively, composition is similar to that of natural apatite. However, spectroscopic results suggest the presence of a mixture of hydroxyapatite and octacalcium phosphate. The different substrate materials have a high influence on the microstructure of the separated double films. However, hydroxyapatite nanopowders coatings were obtained using a simple method, with potential biomedical applications.