Toru Abe

Dr. Toru Abe

Tohoku University, Sendai, Miyagi, Japan
orcid

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 August 2024 in IEEE Internet of Things Journal
Verified
Journal Article
Closed access
MKMina Kato
Mina Kato
TRTiago Koketsu Rodrigues
Tiago Koketsu Rodrigues
TAToru Abe
Toru Abe
TSTakuo Suganuma
Takuo Suganuma
A lot of the devices in the Internet of Things are sensors responsible for capturing environmental information and relaying it to a system or network. Oftentimes, it is important to know the location of these sensors to better contextualize the information received from them. However, the sensors are purposely simple and cheap, meaning that conventional localization techniques, such as global navigation satellite systems are not feasible. Research has been done on using unmanned aerial vehicles to estimate the location of the sensors, but issues with signal strength fluctuation and location approximation because of it are still prevalent. In this work, we propose a new method for estimating the location of sensors by exploiting the characteristics of radio wave signal propagation and creating a new flight path design, a solution to minimize the impact of variation in measurements, a novel candidate point generation through signal strength analysis, and a method to find the location based on the candidates. Through a thought-out experiment, we show that the proposed algorithm is overall significantly better than the existing solution when it comes to identifying the location of outdoor sensors.

1 October 2019
Verified
Conference Paper
Closed access
MCMinya Cai
Minya Cai
MAMuhammad Alfian Amrizal
Muhammad Alfian Amrizal
TAToru Abe
Toru Abe
TSTakuo Suganuma
Takuo Suganuma
In this paper, we propose a system to support piano class learning with Augmented Reality (AR) technology. The system composes of several key functionalities: 1) real-time highlighted key pressing, 2) virtual hand models, and 3) instruction mapping between music sheet and keyboard. We aim to boost learners' interest in learning piano by enhancing the study experience using AR technology.

4 August 2019 in Electronics
Verified
Journal Article
Open access
PDF file
LGLuis Guillen
Luis Guillen
SISatoru Izumi
Satoru Izumi
TAToru Abe
Toru Abe
TSTakuo Suganuma
Takuo Suganuma
Dynamic Adaptive Streaming over HTTP (DASH) is a widely used standard for video content delivery. Video traffic, most of which is generated from mobile devices, is shortly to become the most significant part of Internet traffic. Current DASH solutions only consider either client- or server-side optimization, leaving other components in DASH (e.g., at the transport layer) to default solutions that cause a performance bottleneck. In that regard, although it is assumed that HTTP must be necessarily transported on top of TCP, with the latest introduction of HTTP/3, it is time to re-evaluate its effects on DASH. The most substantial change in HTTP/3 is having Quick UDP Internet Connections (QUIC) as its primary underlying transport protocol. However, little is still know about the effects on standard DASH client-based adaption algorithms when exposed to the future HTTP/3. In this paper, we present SAND/3, an SDN (Software Defined Networking)-based Quality of Experience (QoE) control method for DASH over HTTP/3. Since the official deployment of HTTP/3 has not been released yet, we used the current implementation of Google QUIC. Preliminary results show that, by applying SAND/3, which combines information from different layers orchestrated by SDN to select the best QoE, we can obtain steadier media throughput, reduce the number of quality shifts in at least 40%, increase the amount downloaded content at least 20%, and minimize video interruptions compared to the current implementations regardless of the client adaption algorithm.

23 June 2021 in International Journal of Network Management
Verified
Journal Article
Open access
PDF file
DODaichi Ono
Daichi Ono
LGLuis Guillen
Luis Guillen
SISatoru Izumi
Satoru Izumi
TAToru Abe
Toru Abe
TSTakuo Suganuma
Takuo Suganuma
Summary: By quickly detecting a port scan and blocking the culprit host from the network, it is possible to minimize the spread of the damage by infected hosts and malicious users. In the past, various Software‐Defined Networking (SDN)‐based methods have been proposed, whose main advantage is the lower overhead compared to traditional methods that collect and analyze all captured traffic. On the other hand, due to the polling process used in these methods, it is necessary to set a short interval (e.g., few seconds) to keep the attacks' detection as short as possible. However, when the attack frequency is very low compared to normal traffic, there is an unnecessary overhead. In this paper, we propose a port scan detection method that considers the characteristics of Packet‐In messages sent from the OpenFlow (OF) switch to the controller. This allows a prompt detection and with less overhead than conventional polling methods. The evaluation was conducted using both simulated and real traffic data. Results confirm that the proposed method can detect port scans with lower overhead than existing methods.

3 August 2020 in IEEE Access
Verified
Journal Article
Open access
LGLuis Guillen
Luis Guillen
HTHiroyuki Takahira
Hiroyuki Takahira
SISatoru Izumi
Satoru Izumi
TAToru Abe
Toru Abe
TSTakuo Suganuma
Takuo Suganuma
Network survivability is the ability to maintain service continuity in the presence of failures. This ability might be critical in times where large-scale failures occur, as in the case of disasters. In the past years, Software Defined Networking (SDN) has shown a great potential to allow network programmability by segregating the Control/Management Plane (C/M-Plane) from the forwarding or Data Plane (D-Plane). The controller, a centralized entity, has an overview of the entire network under its domain, which allows it to make informed routing decisions. However, the controller becomes a single-point-of-failure as network devices will have limited knowledge if not connected to a controller. Moreover, in disaster situations, if the affected area is considerably large, there is a high probability that more than a single controller will fail in a short period. Various studies, either following a protection or restoration techniques, have been proposed to address resiliency on SDN, but most of them only consider link or device failure; however, the failure of various controllers due to a large-scale disaster is less explored. In this paper, we consider multi-controller failure and propose a mechanism to reduce the non-operational network devices in disaster situations. Preliminary results show that, by applying the proposed approach, it is possible to achieve substantial improvements in network survivability, with considerably less cost of implementation than existing methods. In particular, using simulation, we achieved a 20% decrease of non-operational devices at the C/M-Plane; and an increase of 30% of success rate at the D-Plane, even if half of the controllers in the topology failed.

6 September 2022 in Sensors
Verified
Journal Article
Open access
PDF file
JWJiahao Wen
Jiahao Wen
TAToru Abe
Toru Abe
TSTakuo Suganuma
Takuo Suganuma
To provide analytic materials for business management for smart retail solutions, it is essential to recognize various customer behaviors (CB) from video footage acquired by in-store cameras. Along with frequent changes in needs and environments, such as promotion plans, product categories, in-store layouts, etc., the targets of customer behavior recognition (CBR) also change frequently. Therefore, one of the requirements of the CBR method is the flexibility to adapt to changes in recognition targets. However, existing approaches, mostly based on machine learning, usually take a great deal of time to re-collect training data and train new models when faced with changing target CBs, reflecting their lack of flexibility. In this paper, we propose a CBR method to achieve flexibility by considering CB in combination with primitives. A primitive is a unit that describes an object’s motion or multiple objects’ relationships. The combination of different primitives can characterize a particular CB. Since primitives can be reused to define a wide range of different CBs, our proposed method is capable of flexibly adapting to target CB changes in retail stores. In experiments undertaken, we utilized both our collected laboratory dataset and the public MERL dataset. We changed the combination of primitives to cope with the changes in target CBs between different datasets. As a result, our proposed method achieved good flexibility with acceptable recognition accuracy.