The particle shape of coral sand is a crucial factor that affects its accumulation characteristics. Two-dimensional particle images of coral sand with different particle sizes were obtained through optical imaging, and the basic size parameters of particles were measured by digital image processing. The particle shape parameters were created, and on this basis, the variation of shape parameters with size, the distribution characteristics, and the sensitivity of shape parameters were analyzed by mathematical statistics and the fractal theory. In addition, a comparative analysis was conducted for the particle shape and bulk density of coral sand and quartz sand with the same particle size. The results show that (1) for coral sand with particle size ranging from 0.5 to 5.0 mm, as the particle size augments, its overall profile coefficient grows, while the flatness, angularity, and roughness diminish and the particle shape deviates more from the regular circle. (2) The shape of coral sand particles exhibits good fractal characteristics, and the particle shape gets more complex as the particle size grows as evidenced by the fact that the fractal dimension enlarges. (3) All the shape parameters obey a skewed distribution. Concerning the sensitivity to the change in particle shape, the flatness occupies the first place, the overall profile coefficient and angularity come second, and the roughness ranks third, accordingly. It is suggested that flatness should be preferred as the evaluation parameter of the particle shape. (4) Compared with that of quartz sand, the particle shape of coral sand is more irregular, and the intergranular pores are larger under the same accumulation conditions, which is the primary reason why the specific gravity of coral sand is greater than that of quartz sand while the bulk density is smaller than that of quartz sand.

In this article, the dilatancy of calcareous soil is studied systematically based on triaxial consolidation drainage shear tests, and the difference in dilatancy between calcareous soil and siliceous soil is also investigated. It was found that: ① Calcareous soil experience obvious dilated deformation. Dilatancy tendency increases with increasing related density and decreases with increasing confining pressure. ② The volumetric strain rate initially increases from negative to positive. After it reaches a maximum, there is a small decrease in the volumetric strain rate, but it is still greater than zero, and the stress-strain curves are of softening type. ③ For the same condition, the dilatancy deformation of calcareous sand begins later than that of siliceous sand, and the volume compression before dilatancy is also larger for calcareous sand. ④ The critical state alone cannot accurately describe the entire deformation process of soil, and it is proposed that the phase transformation state be added to the standard method used to assess soil dilatation and contraction. ⑤ Based on the statistical analysis of experimental data, mathematical relationships were established between void ratio, relative density, and effective confining pressure of phase transformation state and critical state, respectively.

The effect of capillary water caused by heavy rainfall and groundwater level fluctuations can induce the erosion and collapse of island reef coral sand foundations. Here, the effects of water content (ω) on the shear strength parameters of coral gravelly sand are analyzed at the macro and micro scales by laboratory consolidated-drained triaxial compression and nuclear magnetic resonance tests. Furthermore, particle breakage characteristics of coral gravelly sand under the static load are discussed. With increasing ω, (1) the internal friction angle increases slightly ( 11.1%; and (6) the particle breakage increases, and there is an approximately linear relationship between the median particle diameter (d₅₀) and relative breakage index (Br). The established physical model can reflect the influence of water content and plastic work and describe the evolution law of particle breakage.

The pore-throat network of rock exerts a vital influence on the permeability and mechanical properties of the rock. Resorting to X-ray micro-CT scanning, the present work investigates the pore-throat structure of marine biogenic carbonate samples from the South China Sea and compares them to terrigenous sedimentary sandstone. With the help of the maximum ball (MB) algorithm, the pore-throat networks inside representative elementary volumes of rock samples are revealed by stick-and-ball diagrams, which enables quantitative analyses afterwards. Higher and more deviant cross sectional porosity was observed for the carbonate samples compared to the sandstone sample, indicating relatively heterogeneous pores in the carbonate. Over 85% of pores in the carbonate samples were classified as mesopores. Irregular triangular cross sections can be inferred for the pores and throats of the carbonate. The type of rock and the porosity seem to have little effect on the shapes of the pores and throats. In the studied carbonate, the average volume of the throat was approximately one order of magnitude smaller than the average volume of a pore. The distribution of throat radius differed significantly between the studied carbonate samples. The average coordination number of the carbonate was measured to be 1.

The coefficient of lateral pressure at rest (k₀) is a key parameter required to determine the horizontal stress distribution on subsoils. In this paper, k₀ was measured from consolidation test for calcareous and siliceous sand, and the effect of water contents on k₀ of calcareous sand was also discussed. Comparison of k₀ values measured and calculated based on empirical formulas were carried on. Results indicated that (1) the reduction rate of k₀ for calcareous sand with an increase in relative density was less than that of siliceous sand. The k₀ at low water content was generally smaller than that of siliceous sand, and it was similar to that of siliceous sand for high-water content; (2) the k₀ of calcareous sand increased with increasing initial water content initially, and then decreasing. However, the magnitude of variation was small. So the impact of water content on the k₀ of calcareous sand was limited; (3) the formulas proposed by Abdelhamid and Krizek ( 1976 Abdelhamid, M. S. , and R. J. Krizek. 1976. At-Rest Lateral Earth Pressure of Consolidating Clay. Journal of the Geotechnical Engineering Division 102 (7): 721–738. [Google Scholar] ) for estimation of the k₀ was highly applicable to calcareous fine sand.