We demonstrate polarization mode selection in a two-dimensional (2D) photonic crystal laser by controlling the geometry of the unit cell structure. As the band diagram of the square-lattice photonic crystal is influenced by the unit cell structure, calculations reveal that changing the structure from a circular to an elliptical geometry should result in a strong modification of the electromagnetic field distributions at the band edges. Such a structural modification is expected to provide a mechanism for controlling the polarization modes of the emitted light. A square-lattice photonic crystal with the elliptical unit cell structure has been fabricated and integrated with a gain media. The observed coherent 2D lasing action with a single wavelength and controlled polarization is in good agreement with the predicted behavior.
Three-dimensional (3D) photonic crystals containing artificial point defects have been fabricated to emit light at optical communications wavelengths. They were constructed by stacking 0.7-micrometer-period gallium arsenide striped layers, resulting in a 3D “woodpile” photonic crystal. Indium–gallium arsenide–phosphide quantum-well layers emitting at a wavelength of 1.55 micrometers were incorporated in the center of the crystal. Samples having up to nine stacked layers were constructed, and artificial point-defect cavities of different sizes were formed in the light-emitting layer. Light emission was suppressed in the photonic crystal regions, whereas cavity modes were successfully observed at the point defects and were size dependent.
The lasing mode of a two-dimensional (2D) photonic crystal laser with in-plane multidirectionally distributed feedback effect is analyzed theoretically and experimentally. From an investigation of the Bragg diffraction conditions at several points in the photonic band diagram where lasing is expected, we identify a particular Γ point at which lasing occurs due to the coupling of lightwaves propagating in six equivalent Γ-X directions and diffraction normal to the substrate surface. In order to investigate the lasing mode in detail, the distribution of the electromagnetic field at the band edges at the Γ point is calculated, and each band edge is found to have a different field pattern. The lasing characteristics of the 2D photonic crystal laser at the lasing wavelength corresponding to the Γ point are measured. Single-mode lasing over a broad circular area is observed by microelectroluminescence measurements under pulsed conditions at room temperature. We also demonstrate the correspondence between the measured lasing wavelengths and calculated band edges by comparing the polarization characteristics with the calculated distribution of the electromagnetic field. The results indicate that 2D coherent lasing oscillation does, in fact, occur due to the multidirectional coupling effect in the 2D photonic crystal. From the theoretical calculation, we show that the polarization patterns of the lasers can be controlled by introducing artificial lattice defects.