The transdermal route of drugs has received increased attention in recent years due to numerous advantages over the oral and injectable routes, such as avoidance of the hepatic metabolism, protection of drugs from the gastrointestinal tract, sustained drug delivery, and good patient compliance. The assessment of ex vivo permeation during the pharmaceutical development process helps in understanding the product quality and performance of a transdermal delivery system. Generally, excised human skin relevant to the application site or animal skin is recommended for ex vivo permeation studies. However, the limited availability of the human skin and ethical issues surrounding the use of animal skin rendered these models less attractive in the permeation study. In the last three decades, enormous efforts have been put into developing artificial membranes and 3D cultured human skin models as surrogates to the human skin. This manuscript provides an insight on the European Medicines Agency (EMA) guidelines for permeation studies and the parameters affected when using Franz diffusion cells in the permeation study. The need and possibilities for skin alternatives, such as artificially cultured human skin models, parallel artificial membrane permeability assays (PAMPA), and artificial membranes for penetration and permeation studies, are comprehensively discussed.

Topical drug delivery is an attractive alternative to conventional methods because of advantages such as non-invasive delivery, by-pass of first pass metabolism, and improved patient compliance. However, several factors such as skin, physicochemical properties of the drug, and vehicle characteristics influence the permeation. Within a formulation, critical factors such as concentration of drug, physical state of drug in the formulation, and organoleptic properties affect the flux across the skin. The aim of the study was to develop and investigate topical semisolid preparations (creams and gels) with ibuprofen as the model drug and investigate the effect of various formulation parameters on the in-vitro performance across the Strat-M^® membrane using flow-through cells. In addition, the physical stability of the developed formulations was investigated by studying viscosity, pH, and appearance. All the formulations developed in the study had appealing appearance with smooth texture and no signs of separation. Viscosity and pH of the formulations were acceptable. Cumulative amount of drug permeated at the end of 24 h was highest for clear gel (3% w/w ibuprofen; F6: 739.6 ± 36.1 µg/cm²) followed by cream with high concentration of ibuprofen in suspended form (5% w/w; F3: 320.8 ± 17.53 µg/cm²), emulgel (3% w/w ibuprofen; F5: 178.5 ± 34.5 µg/cm²), and cream with solubilized ibuprofen (3% w/w; F2A: 163.2 ± 9.36 µg/cm²). Results from this study showed that permeation of ibuprofen was significantly influenced by formulation parameters such as concentration of ibuprofen (3% vs. 5% w/w), physical state of ibuprofen (solubilized vs. suspended), formulation type (cream vs. gel), mucoadhesive agents, and viscosity (high vs. low). Thus, findings from this study indicate that pharmaceutical formulation scientists should explore these critical factors during the early development of any new topical drug product in order to meet pre-determined quality target product profile.

Global incidence of superficial fungal infections caused by dermatophytes is high and affects around 40 million people. It is the fourth most common cause of infection. Clotrimazole, a broad spectrum imidazole antifungal agent is widely used to treat fungal infections. Conventional topical formulations of clotrimazole are intended to treat infections by effective penetration of drugs into the stratum corneum. However, drawbacks such as poor dermal bioavailability, poor penetration, and variable drug levels limit the efficiency. The present study aims to load clotrimazole into ufosomes and evaluate its topical bioavailability. Clotrimazole loaded ufosomes were prepared using cholesterol and sodium oleate by thin film hydration technique and evaluated for size, polydispersity index, and entrapment efficiency to obtain optimized formulation. Optimized formulation was characterized using scanning electron microscopy (SEM), X-ray diffraction (XRD), and differential scanning calorimetry (DSC). Skin diffusion studies and tape-stripping were performed using human skin to determine the amount of clotrimazole accumulated in different layers of the skin. Results showed that the optimized formulation had vesicle size <250 nm with ~84% entrapment efficiency. XRD and DSC confirmed the entrapment of clotrimazole into ufosomes. No permeation was observed through the skin up to 24 h following the permeation studies. Tape-stripping revealed that ufosomes led to accumulation of more clotrimazole in the skin compared to marketed formulation (Perrigo). Overall, results revealed the capability of ufosomes in improving the skin bioavailability of clotrimazole.

Age related macular degeneration (AMD) is one of the leading causes of visual loss and is responsible for approximately 9% of global blindness. It is a progressive eye disorder seen in elderly people (>65 years) mainly affecting the macula. Lutein, a carotenoid, is an antioxidant, and has shown neuroprotective properties in the retina. However, lutein has poor bioavailability owing to poor aqueous solubility. Drug delivery to the posterior segment of the eye is challenging due to the blood–retina barrier. Retinal pigment epithelium (RPE) expresses the sodium-dependent multivitamin transporter (SMVT) transport system which selectively uptakes biotin by active transport. In this study, we aimed to enhance lutein uptake into retinal cells using PLGA–PEG–biotin nanoparticles. Lutein loaded polymeric nanoparticles were prepared using O/W solvent-evaporation method. Particle size and zeta potential (ZP) were determined using Malvern Zetasizer. Other characterizations included differential scanning calorimetry, FTIR, and in-vitro release studies. In-vitro uptake and cytotoxicity studies were conducted in ARPE-19 cells using flow cytometry and confocal microscopy. Lutein was successfully encapsulated into PLGA and PLGA–PEG–biotin nanoparticles (<250 nm) with uniform size distribution and high ZP. The entrapment efficiency of lutein was ≈56% and ≈75% for lutein-loaded PLGA and PLGA–PEG–biotin nanoparticles, respectively. FTIR and DSC confirmed encapsulation of lutein into nanoparticles. Cellular uptake studies in ARPE-19 cells confirmed a higher uptake of lutein with PLGA–PEG–biotin nanoparticles compared to PLGA nanoparticles and lutein alone. In vitro cytotoxicity results confirmed that the nanoparticles were safe, effective, and non-toxic. Findings from this study suggest that lutein-loaded PLGA–PEG–biotin nanoparticles can be potentially used for treatment of AMD for higher lutein uptake.

Cryoprotectants are often required in lyophilization to reduce or eliminate agglomeration of solute or suspended materials. The aim of this study was to select a cryoprotecting agent and optimize its concentration in a solid lipid nanoparticle formulation. Progesterone-loaded stearic acid solid lipid nanoparticles (SA-P SLNs) were prepared by hot homogenization with high speed mixing and sonication. The stearic acid content was 4.6% w/w and progesterone was 0.46% w/w of the initial formulation. Multiple surfactants were evaluated, and a lecithin and sodium taurocholate system was chosen. Three concentrations of surfactant were then evaluated, and a concentration of 2% w/w was chosen based on particle size, polydispersity, and zeta potential. Agglomeration of SA-P SLNs after lyophilization was observed as measured by increased particle size. Dextran, glycine, mannitol, polyvinylpyrrolidone (PVP), sorbitol, and trehalose were evaluated as cryoprotectants by both an initial freeze–thaw analysis and after lyophilization. Once selected as the cryoprotectant, trehalose was evaluated at 5%, 10%, 15%, and 20% for optimal concentration, with 20% trehalose being finally selected as the level of choice. Evaluation by DSC confirmed intimate interaction between stearic acid and progesterone in the SA-P SLNs, and polarized light microscopy shows successful lyophilization of the trehalose/SA-P SLN. A short term 28-day stability study suggests the need for refrigeration of the final lyophilized SA-P SLNs in moisture vapor impermeable packaging.

To prepare and characterise lutein-loaded polylactide-co-glycolide–polyethylene glycol–folate (PLGA-PEG-FOLATE) nanoparticles and evaluate enhanced uptake in SK-N-BE(2) cells. Nanoparticles were pr...