We report on the results of a multi-laboratory study to measure the steady state growth stress of planar copper thin films, electrodeposited from additive-free acidic sulfate electrolyte. Measurements were made using the wafer curvature method, which enabled the stress to be measured in real time as the films were grown. The stress trends toward compressive at low growth rate and becomes increasingly tensile as the growth rate is increased, with a similar dependence observed in each laboratory when the films have comparable grain sizes. The results are explained by a model for stress that focuses on processes that occur at the triple junction between the film surface and the grain boundary as the film grows.
Residual stress during thin film deposition is affected by the evolution of the microstructure. This can occur because subsurface grain growth directly induces stress in the film and because changing the grain size at the surface affects the stress in new layers as they are deposited. We describe a new model for stress evolution that includes both of these effects. It is used to explain stress in films that grow with extensive grain growth (referred to as zone II) so that the grain size changes throughout the thickness of the layer as the film grows. Equations are derived for different cases of high or low atomic mobility where different assumptions are used to describe the diffusion of atoms that are incorporated into the grain boundary. The model is applied to measurements of stress and grain growth in evaporated Ni films. A single set of model parameters is able to explain stress evolution in films grown at multiple temperatures and growth rates. The model explains why the slope of the curvature measurements changes continuously with thickness and attributes it to the effect of grain size on new layers deposited on the film.
Magnetizing a cryogenic deuterium–tritium (DT)-layered inertial confinement fusion (ICF) implosion can improve performance by reducing thermal conduction and improving DT-alpha confinement in the hot spot. A room-temperature, magnetized indirect-drive ICF platform at the National Ignition Facility has been developed, using a high-Z, high-resistivity AuTa4 alloy as the hohlraum wall material. Experiments show a 2.5× increase in deuterium–deuterium (DD) neutron yield and a 0.8-keV increase in hot-spot temperature with the application of a 12-T B-field. For an initial 26-T B-field, we observed a 2.9× yield increase and a 1.1-keV temperature increase, with the inferred burn-averaged B-field in the compressed hot spot estimated to be 7.1 ± 1.8 kT using measured primary DD-n and secondary DT-n neutron yields.
Significant challenges have been faced in the manufacturing of low-stress B C films. Here, we demonstrate a set of process parameters for direct-current magnetron sputter deposition of smooth, high-purity, amorphous B C films with near-zero total residual stress and with thicknesses up to 10 m. Films are characterized by a combination of high-energy ion scattering, x-ray diffraction, electron microscopy, and stress measurements based on substrate curvature. In order to facilitate the process transfer to other sputtering geometries, the favorable deposition conditions are correlated with distributions of landing energies and incident angles of depositing species estimated by Monte Carlo simulations of ballistic collisions and gas phase atomic transport. Based on such simulations, a decrease in compressive stress with increasing Ar working gas pressure is attributed to the corresponding broadening of the angular distribution of depositing species and associated atomic shadowing effects.