The quest to reduce fluoride in groundwater to WHO acceptable limit of 1.5 mg/L to prevent diseases such as teeth mottling and skeletal fluorosis was the motivation for this study. Al/Fe oxide-modified diatomaceous earth was prepared and its defluoridation potential evaluated by batch method. The sorbent with pHpzc 6.0 ± 0.2 is very reactive. The maximum 82.3% fluoride removal attained in 50 min using a dosage of 0.3 g/100 mL in 10 mg/L fluoride was almost attained within 5 min contact time; 81.3% being the percent fluoride removal at 5 min contact time. The sorbent has a usage advantage of not requiring solution pH adjustment before it can exhibit its fluoride removal potential. A substantial amount of fluoride (93.1%) was removed from solution when a sorbent dosage of 0.6 g/100 mL was contacted with 10 mg/L fluoride solution for 50 min at a mixing rate of 200 rpm. The optimum adsorption capacity of the adsorbent was 7.633 mg/g using a solution containing initially 100 mg/L fluoride. The equilibrium pH of the suspensions ranged between 6.77 and 8.26 for 10 and 100 mg/L fluoride solutions respectively. Contacting the sorbent at a dosage of 0.6 g/100 mL with field water containing 5.53 mg/L at 200 rpm for 50 min reduced the fluoride content to 0.928 mg/L—a value below the upper limit of WHO guideline of 1.5 mg/L fluoride in drinking water. The sorption data fitted to both Langmuir and Freundlich isotherms but better with the former. The sorption data obeyed only the pseudo-second-order kinetic, which implies that fluoride was chemisorbed.
27 August 2015 in Desalination and Water Treatment
In Sub-Saharan Africa, many rural communities depend on boreholes as the most appropriate source of water supply. Sadly, water from some of the boreholes contains fluoride above the WHO guideline of 1.5 mg/L. Hence, defluoridation is necessary. The aim of this study is to investigate the fluoride uptake capacity of diatomaceous earth (DE), a natural resource at optimized conditions by batch method. X-ray fluorescence analysis showed that the major component is silica (83.1%), while Al2O3 is the main minor component. XRD shows it is an amorphous material. For 8 mg/L fluoride spiked water, the highest per cent fluoride removal at optimum adsorption conditions (contact time: 30 min, adsorbent dosage: 8 g/L, pH 2, temperature: 298 K and shaking speed: 200 rpm) was between 23.4 and 25.6%. in tested field water was observed to reduce the fluoride uptake capacity of fluoride. The sorption data fitted better into Freundlich isotherm than Langmuir isotherm. Fluoride sorption process was found to be a second-order kinetic. Inductively coupled plasma-mass spectrometer analysis of treated water revealed that metal and non-metal species were released at trace levels. Modification of DE would be necessary to enhance the fluoride adsorption capacity of DE.
This study was carried out to appraise the groundwater fluoride removal effectiveness of Al-Fe oxide-infused diatomaceous earth (DE) in a continuous-flow fixed-bed column. The adsorbent was optimally synthesized and then characterized. A glass column designed for the experiment was packed with the test adsorbent at specific doses. The effects of flow rate, influent fluoride concentration and bed height (adsorbent dose) on fluoride removal were evaluated by fixing the value of a parameter while varying the others. The breakthrough volume was the volume of treated water obtained until the concentration of fluoride in the treated water reached 1.5 mg/L, which is the World Health Organization’s maximum limit of fluoride in drinking water. The maximum breakthrough volume obtained in this study was 118.2 mL under the optimum conditions of influent F− concentration = 5 mg/L, 1 g of adsorbent with an initial bed height = 7.5 cm and a flow rate = 1.97 mL/min. Channeling and the presence of as a co-existing anion were limiting factors for the attainment of the breakthrough volume for groundwater defluoridation. Further work is encouraged to investigate a suitable binder that can hold the adsorbent particles firmly together, is not water-soluble, but remains water-permeable when dry. The resulting solid mass could then be pulverized into granules whose weight and rigidity would make them less susceptible to the channeling effect in the column.
An evaluation of the effects of calcination temperature and solution pH on the fluoride removal capacity of Al/Fe oxide-modified diatomaceous earth was carried out. The sorbent was observed to be most effective and stable within the pH range 6.70–8.12, where the lowest concentrations of Al and Fe (<1 mg/L) in treated water were recorded. Thus, sorbent loss was minimal at that pH range. It was observed that the sorbent lost its efficiency and stability at calcination temperatures above 600 °C. Inductively coupled plasma-mass spectrometer analysis of metals in supernatants and thermogravimetric analysis of the sorbent showed that there was substantive loss of Al and Fe from the sorbent at temperatures above 600 °C because of evaporation. K2SO4 solution proved to be the best regenerant for spent sorbent compared to NaOH and Na2CO3, which caused sorbent loss owing to high solution pH. The CO32– from Na2CO3 bound to regenerated sorbent so much that it could not be displaced by fluoride during subsequent defluoridation experiments. Sorbent regenerated with 0.1 M K2SO4 solution could reduce 10 mg/L fluoride in artificial water at a dosage of 0.8 g/100 mL by 81.8% and 67.2% at the second and third cycles, respectively.
1 May 2025 in European Journal of Ecology, Biology and Agriculture
Rice is a staple food consumed worldwide, with nutritional and antinutritional compositions varying across different varieties. This study aimed to assess the morphological, proximate, antinutritive, mineral, and vitamin compositions of four rice varieties: Maharami, Lal Quilla, Owena, and Igbimo. Standard methods were used for proximate, antinutritive, mineral, and vitamin analyses. Morphological analysis revealed varying grain sizes and weights, with Lal Quilla exhibiting the longest grains (7.8 mm) and Maharami having the highest 1000-grain weight (29.85 g). The proximate composition showed carbohydrate content ranging from 76.29% to 78.79%, with Maharami having the highest energy value (1473.89 kJ/100g). Antinutritive analysis revealed saponin and alkaloid contents between 1.42-3.43% and 2.67-12.76%, respectively, with Lal Quilla showing the highest phenol (27.84 mg GAE/g) and flavonoid content (24.64 mg QE/g). Mineral composition showed significant variations, with Owena having the highest potassium (4.018 mg/100g) and Maharami the highest iron (0.060 mg/100g). Vitamin content was consistent across all samples, with Igbimo having the highest Vitamin B3 (2.618 mg/100g). These findings indicate the nutritional potential of these rice varieties, with Maharami and Lal Quilla being particularly rich in energy and bioactive compounds, respectively, making them promising for dietary applications.
The increase in bacterial infections has necessitated the need for the design of new drugs that can fight against multidrug-resistant bacteria. Schiff bases, especially those of vanillin, have shown promising activity against some bacterial infections. In this article, six new vanillin Schiff bases (L1–L6) were prepared by condensation of vanillin with various substituted anilines for possible medicinal applications. The compounds were characterized by infrared spectra, UV/visible spectra, and melting point measurements. Infrared spectra confirmed the formation of the compounds by the newly emerged azomethine (C=N) bands observed at 1676–1620 cm⁻¹ for the synthesized compounds. The UV/visible spectra showed the expected π–π* transition of the azomethine group at 38000–34000 cm⁻¹ and the n–π* transition at 32000–25000 cm⁻¹, which are characteristics of the molecules. The Schiff bases, L5 and L6, were obtained as thick viscous liquids, while L1–L4 came out as crystals of different colors characterized by sharp melting points. The molecules were modeled and optimized using DFT at the 6-31G(d) level of theory. The computational study shows that the compounds could effectively accept and donate protons, which is a remarkable characteristic for medicinal and other applications. The characterization results reveal that the compounds were successfully prepared. Spectroscopic and computational studies suggested that the compounds may have some medicinal and electronic applications.