In this research, hydroxyapatite (HA)–chitosan–titania nanocomposite coatings were formed on 316 L stainless steel using electrophoretic deposition (EPD) from alcoholic (methanol and ethanol) suspensions containing 0.5 g/L chitosan and 2 and 5 g/L HA and 2 and 5 g/L Titania. The effect of different parameters on the deposition rate, morphology, and corrosion resistance of the coatings in simulated body fluid (SBF) at 37 °C has been studied. The coatings’ properties were investigated using Fourier-transform infrared spectroscopy (FTIR) and scanning electron microscope (SEM). Based on the results of this work, it was found that the deposition rate in ethanolic suspensions is lower than methanolic ones. Moreover, the coating surface was smoother when the ethanol was used as a solvent in suspensions in comparison to the ones where methanol was the solvent. The coating deposited from a suspension containing 0.5 g/L chitosan, 2 g/L HA, and 5 g/L titania with ethanol as solvent had the highest corrosion resistance in SBF at 37 °C.
Suspensions of HA nanoparticles were prepared in different alcohols using triethanolamine (TEA) as dispersant. Optimum concentration of TEA increased with molecular weight of alcohol: 0.67, 0.67 and 8mL/L, respectively, in methanolic, ethanolic and butanolic suspensions. Current density increased during EPD from TEA containing methanolic and ethanolic suspensions due to desorption of H+TEA ions from deposited HA nanoparticles under the influence of applied electric field. Particles were detached from deposits into the suspensions at the interface after switching off the voltage due to the generation of an electrochemical potential difference there. The rate of detachment decreased continuously in all methanolic suspensions and ethanolic suspensions with 4mL/L ≤ TEA due to the continuous reduction in the electrochemical potential difference at the interface caused by the effective diffusion of high concentration of free TEA and H+TEA species present in the liquid phase of deposits into the suspension. However, the rate of detachment remained constant in ethanolic suspensions with TEA < 4mL/L and in all butanolic suspensions. The mass flow of TEA and H+TEA species from deposit into the suspensions is negligible in these suspensions so that the electrochemical potential difference and so detachment rate remain constant.