“Bottom-up” additive manufacturing (AM) is the technology whereby a digitally designed structure is built layer-by-layer, i.e., differently than by traditional manufacturing techniques based on subtractive manufacturing. AM, as exemplified by 3D printing, has gained significant importance for scientists, among others, in the fields of catalysis and separation. Undoubtedly, it constitutes an enabling pathway by which new complex, promising and innovative structures can be built. According to recent studies, 3D printing technologies have been utilized in enhancing the heat, mass transfer, adsorption capacity and surface area in CO2 adsorption and separation applications and catalytic reactions. However, intense work is needed in the field to address further challenges in dealing with the materials and metrological features of the structures involved. Although few studies have been performed, the promise is there for future research to decrease carbon emissions and footprint. This review provides an overview on how AM is linked to the chemistry of catalysis and separation with particular emphasis on reforming reactions and carbon adsorption and how efficient it could be in enhancing their performance.
Volatile fatty acids (VFAs) are carboxylic acids mainly produced via the fermentation of organic waste streams. Being industrial platform chemicals, sustainable, green and economical recovery of VFAs is necessary. Herein, hydrophobic deep eutectic solvents (HDES), “a new generation of water-immiscible designer solvents”, were assessed for the recovery of VFAs via liquid–liquid extraction. The eutectic mixture of menthol-lauric acid exhibited the highest stability and hydrophobicity. The binary solubility of the pairs {VFA in water} and {VFA in HDES}—and the saturation of the HDES with water were measured. Furthermore, the influences of key parameters on the extraction efficiency were investigated. On multi-stage extraction, an efficiency of 88% was achieved in 4 stages, and the HDES was successfully regenerated using vacuum evaporation. The HDES performance was also compared to other reported relevant solvents. It was concluded that menthol-lauric acid HDES is a promising candidate for the green extraction of VFAs from fermented wastewater.
Selective altering of surface wettability in microfluidic channels provides a suitable platform for a large range of processes, such as the phase separation of multiphase systems, synthesis of reaction controlled, nanoliter sized droplet reactors, and catalyst impregnation. Herein we study the feasibility to tune the wettability of a flexible cyclic olefin copolymer (COC). Two methods were considered for enhancing the surface hydrophilicity. The first is argon/oxygen plasma treatment, where the effect of treatment duration on water contact angle and COC surface morphology and chemistry were investigated, and the second is coating COC with GO dispersions of different concentrations. For enhancing the hydrophobicity of GO-coated COC surfaces, three reduction methods were considered: chemical reduction by Hydroiodic acid (HI), thermal reduction, and photo reduction by exposure of GO-coated COC to UV light. The results show that as the GO concentration and plasma treatment duration increased, a significant decrease in contact angle was observed, which confirmed the ability to enhance the wettability of the COC surface. The increase in hydrophilicity during plasma treatment was associated with the increase in surface roughness on the treated surfaces, while the increase during GO coating was associated with introducing oxygen-containing groups on the GO-coated COC surfaces. The results also show that the different reduction methods considered can increase the contact angle and improve the hydrophobicity of a GO-coated COC surface. It was found that the significant improvement in hydrophobicity was related to the reduction of oxygen-containing groups on the GO-coated COC modified surface.
1 February 2020 in Journal of Natural Gas Science and Engineering