Deviation from vertical path makes drill cuttings to accumulate on the lower side of the wellbore that induces the formation of cuttings bed. Subsequently, relative problems occur while drilling. Excessive torque and drag, difficulties in running casing in hole and accomplishing good cementing jobs and mechanical pipe sticking are few of the classical examples of such problems. Therefore, a comprehensive understanding of influential parameters on hole cleaning seems to be essential. This paper indicates the results of an experimental study that was carried out to evaluate cuttings removal efficiency using three types of drilling fluid. The experimental works were conducted using a 17-feet long opaque flow loop of 2-in. diameter as the test section. For each test, the amount of cuttings transport performance (CTP) was determined from weight measurements. Viscosity was investigated together with other two influential parameters, namely fluid velocity and hole inclination under various flow conditions. It is shown that the increase in drilling fluid viscosity has improved CTP by approximately 8 % at all angles provided the flow regime remained turbulent while velocity was kept constant. However, further increase of viscosity as flow regime was turning into transient or laminar flow, has lessened CTP by a total average of 12 %. It was also revealed that an incremental escalation in hole inclination from 60° to 90° has a positive effect on CTP, i.e., it will be improved up to 40 %. Drilling fluid velocity was found to have significant impact on CTP as it could attain maximum percentage of 98 %.
Enhancement of foam stability has been recently evidenced with addition of nanoparticles (NPs), especially in the case of CO2 foams. Stabilized foams via solid NPs can potentially withstand high reservoirs temperatures. Studies have been conducted to examine the effect of NPs on foam stability; however, more research is required for various types of NPs. Therefore, the authors aimed to investigate the performance of silicon dioxide (SiO2), aluminum oxide (Al2O3), copper oxide (CuO), and titanium dioxide (TiO2) of different sizes in the presence of fixed concentration of anionic surfactant (AOS) on foam stability. Nano particle concentrations of (0.1 wt%, 0.3 wt%, 0.5 wt%, and 1 wt%) were used to investigate the foam stability, displacement test were performed to determine oil recovery at the optimum concentrations for each nanoparticle. The stability of the aqueous foam was evaluated by the Ross-Miles method using half-life measurements. All experiments were conducted at room temperature and pressure. The results revealed that all different NPs used were able to improve the stability of CO2 foam at certain concentrations. However, aluminum oxide NPs showed better results compared to others in terms of foam stability and half-life time. In addition, 0.1 wt% of all NPs types gave the highest foam stability and half-life time. In conclusion, a low concentration of NPs is recommended regardless of type for improving form stability
1 October 2015 in Flow Measurement and Instrumentation