The design methodology is described for a miniaturized frequency selective surface (FSS) using lumped reactive components. Capacitive and inductive elements are utilized in metallic patches to create current loops similar to that observed in bandpass aperture type FSS. It is shown that the resonant frequency of the FSS is controlled mainly by the values of the lumped components and to a lesser extent by the distance between the components. It is insensitive to the periodicity. Issues such as the effects of component loss and oblique incidence are reported using full field predictions. Measurements are shown for an FSS with unit cell periodicity of ¿/36.
8 October 2007 in IEEE Transactions on Antennas and Propagation
Oblique incidence performance of a novel two-layer absorb/transmit frequency selective surface (FSS) is investigated. The FSS has good frequency stability for both horizontally and vertically polarized waves incident normally or at oblique angles. Due to its transmission for 900/1800/1900 MHz mobile bands and good absorption for 5 GHz waves, it has the potential as a security wall or isolator for 5 GHz WLAN systems. The absorption in the stop band helps reduce additional WLAN multipath fading caused by conventional reflecting FSS designs. The first layer of the FSS consists of conventional conducting cross dipoles having a circular aperture in the centre, while the second layer uses resistive cross dipoles. Moreover, the conducting cross dipoles have been sandwiched between two dielectric sheets to achieve a stable response for different angles of incidence. The periodicity of both FSS layers is the same while the distance between the two layers is reduced to one eighth of the free-space wavelength. This reduction leads to a more compact design compared to the conventional Salisbury screen, while still achieving acceptable absorption in the stopband. Both theoretical and experimental results are presented to confirm the performance of the absorb/transmit FSS.
4 December 2009 in IEEE Transactions on Antennas and Propagation
A frequency selective surface (FSS) that is electronically switchable between reflective and transparent states is tested. It can be used to provide a spatial filter solution to reconfigure the electromagnetic architecture of buildings. The FSS measurements show that the frequency response of the filter does not change significantly when the wave polarization changes or the angle of incidence changes up to ±45° from normal. The FSS is based on square loop aperture geometry, with each unit cell having four PIN diodes across the aperture at 90 degree intervals. Experiments demonstrated that almost 10 dB additional transmission loss can be introduced on average at the resonance frequency, for both polarizations, by switching PIN diodes to on from off state.
1 October 2020 in IEEE Transactions on Antennas and Propagation
A planar metasurface that rotates the polarisation of reflected signals by 90° is presented in this article. The surface also permits the relative phase of the rotated, reflected signal to be controlled. The metasurface rotator uses a square printed patch element mounted above a conducting ground plane. The addition of PIN diode controlled VIAs (Vertical Interconnect Access) at the corners of each square patch provide the ability to modify the scattering properties of the surface. In particular, the surface can be programmed to shift the phase of the rotated waveform by +/-90°. The polarisation rotator was manufactured, measured and compared against numerical simulations and the maximum measured bandwidth was 25% (4.8-6.2 GHz) for co-polarised attenuation of 10 dB. The proposed surface can be adopted for practical applications such as circularly polarised antennas.
A miniaturised frequency selective surface (FSS) loaded with lumped components is presented. The FSS uses inductors and capacitors to provide a bandpass response with a simulated unit cell size of λ/115 with a −3 dB bandwidth of 23.9%. This is the first reported use of the combination of capacitors and inductors to provide miniaturisation to this extent. Measurements are presented to validate the technique, showing an FSS resonating at 945 MHz with 21.9% bandwidth and a unit cell size of λ/18.
28 May 2008 in Microwave and Optical Technology Letters