The paper describes experimental and numerical results of concrete fracture under quasi-static uniaxial compression. Experimental uniaxial compression tests were performed on concrete cubic specimens. Fracture in concrete was detected at the aggregate level by means of three non-destructive methods: three-dimensional X-ray microcomputed tomography, two-dimensional scanning electron microscope and manual two-dimensional digital microscope. The discrete element method was used to directly simulate experiments. Concrete was modelled as a random heterogeneous four-phase material composed of aggregate particles, cement matrix, interfacial transitional zones and macrovoids based on experimental images. Two- and three-dimensional analyses were carried out. In two-dimensional analyses, the real aggregate shape was created by means of clusters of spheres. In three-dimensional calculations, spheres were solely used. A satisfactory agreement between numerical and experimental results was achieved in two-dimensional analyses. The model was capable of accurately predicting complex crack paths and the corresponding stress–strain responses observed in experiments.

The paper describes the preparation and characterization of rigid polyurethane-polyisocyanurate (PUR-PIR) foams obtained with biopolyol synthesized in the process of liquefaction of biomass from the Baltic Sea. The obtained foams differed in the content of biopolyol in polyol mixture (0–30 wt%) and the isocyanate index (I_ISO = 200, 250, and 300). The prepared foams were characterized in terms of processing parameters (processing times, synthesis temperature), physical (sol fraction content, apparent density) and chemical structure (Fourier transform infrared spectroscopy), microstructure (computer microtomography), as well as mechanical (compressive strength, dynamic mechanical analysis), and thermal properties (thermogravimetric analysis, thermal conductivity coefficient). The influence of biopolyol and I_ISO content on the above properties was determined. The addition of up to 30 wt% of biopolyol increased the reactivity of the polyol mixture, and the obtained foams showed enhanced mechanical, thermal, and insulating properties compared to foams prepared solely with petrochemical polyol. The addition of up to 30 wt% of biopolyol did not significantly affect the chemical structure and average cell size. With the increase in I_ISO, a slight decrease in processing times and mechanical properties was observed. As expected, foams with higher I_ISO exhibited a higher relative concentration of polyisocyanurate groups in their chemical structure, which was confirmed using principal component analysis (PCA).

The building sector accounts for 40% of the total energy consumed in Europe at annual basis, together with the relevant Greenhouse Gas (GHG) emissions. In order to mitigate these impacts, the concept and establishment of the Nearly Zero Energy Buildings (NZEBs) is under continuous and intensive research. In fact, as the energy used for buildings’ operation becomes more efficient, impacts resulting from the buildings’ embodied energy become of more importance. Therefore, the selection of building materials and components is of high significance, as these affect the energy performance and potential environmental impacts of the building envelopes. The objective of this study is to perform a preliminary Life Cycle Assessment (LCA) on advanced multifunctional building components, aiming to achieve lower embodied emissions in NZEBs. The advanced components analyzed are composite panels for facade elements of building envelopes, providing thermal efficiency. The design of sustainable building envelope systems is expected to upgrade the overall environmental performance of buildings, including the NZEBs. The findings of this study constitute unambiguous evidence on the need for further research on this topic, as substantial lack of data concerning embodied impacts is presented in literature, adding to the growing discussion on NZEBs at a whole life cycle perspective across Europe. This research has shown that the electricity required from the manufacturing phase of the examined building components is the main contributor to climate change impact and the other environmental categories assessed. Sensitivity analysis that has been performed indicated that the climate change impact is highly depended on the electricity grid energy mix across Europe. Taking into account the current green energy transition by the increase of the renewable energy sources in electricity production, as well as the future upgrade of the manufacturing processes, it is expected that this climate change impact will be mitigated. Finally, the comparison between the CLC thermal insulator and other foam concretes in literature showed that the materials of the building components examined do not present any diversions in terms of environmental impact.