The Monte Corchia cave system, one of the most famous and popular caves in Italy, has in recent times been the subject of investigation on its speleothems as paleoclimate archives. This paper describes the geology, geomorphology and water chemistry of the cave system with the aim to elucidate the processes that have generated these speleothems and the properties they contain that are so useful for paleoclimatology. Some general conclusions can be drawn: i) the Corchia system is a cave developed over different altitudes during progressive uplift of the mountain chain in which it is located, probably under drainage conditions very different to those of the present. This has allowed the development of a large (ca. 60 km) and deep (-1187 m) karst system; ii) the dewatering phases have left the deepest chambers far away from clastic input and with long drip pathways; iii) the peculiar geological context has permitted the water to intercept and dissolve a significant source of U (still unknown) that facilitates radiometric dating; iv) in the last 1 Ma at least, no significant changes have occurred in the relief and in the epikarst, in the sense that speleothems have grown under very similar conditions. In addition the extremely low Ca concentration of drip waters have permitted low speleothem growth rates and, at least for the “Galleria delle Stalattiti”, the zone under paleoclimate studies, a stable plumbing system (i.e. chemistry and stable isotopes of drip waters) has produced calcite close to isotopic equilibrium.

The Terme Sibarite and nearby thermomineral water discharges have Ca-SO4 to Ca-SO4-HCO3 composition, near neutral pH value of 6.9 to 7.6, outlet temperatures of 16° to 25.5°C, variable redox potentials (-0.23 to 0.2 V) and total dissolved solids from 20 to 35 meq L-1. The total flow rate of the Terme Sibarite springs is about 130 L s-1. Solubility of chalcedony and the K-Mg geothermometer show a full equilibrium reservoir temperature of 33°C. The δ34S values of dissolved sulfate are constrained by mixing of thermomineral waters with cold waters, both interacting with Upper Triassic carbonate-evaporite rocks, as well as occurrence of bacterial sulfate reduction. In the light of the geological and hydrogeological framework of the study area, this chemical and isotopic evidence suggests that the thermal circuit develops entirely into the Upper Triassic sedimentary sequence, without any interaction with the Messinian evaporites which are possibly present below the Upper Triassic sedimentary sequence. The thermomineral waters are meteoric precipitations infiltrating in the Pollino Massif, at average altitudes of 950-1090 m a.s.l, as indicated by the δ18O values of water. These waters descend to maximum depths of 600 m below the Sibari Plain, where the geothermal reservoir is situated. Circulating into it, waters extract heat from reservoir rocks, attaining thermo-chemical equilibrium at the temperature suggested by chemical geothermometers. Then, the thermomineral waters locally rise relatively quickly to the surface, along subvertical faults and fractures, preserving part of their physical and chemical characteristics. The methodological approach utilized in this research may be applied to other fault-controlled, low-temperature geothermal systems in other zones of Italy and other nations.

The “Scansano-Magliano in Toscana” area is characterized by a morpho-structure chiefly made-up by sandstone and shelly-calcareous lithologies. Generally, these complexes host minor aquifers in Tuscany, since they have medium to medium-low permeability. In the area under examination, a sandstone outcrop develops with continuity along the ridge of the structure for several kilometers and above a shelly substratum. Consequently, this hydrostructural context suggested the possibility that a significant groundwater body was hosted in the sandstones. In order to verify this assumption, an isotopic study was carried out taking into account several wells and springs sited on the sandstone outcrop and its surrounding area; the samples collected over a period of two years were analyzed to obtain δ¹⁸O‰, δ²H‰ and ³H. A study of the hydrostructural and morphological condition was also performed, and minor springs were selected. The analyses of this spring-water resulted in the characterization of the isotopic features of the infiltration water in the studied area, which represents a fundamental base of work for the interpretation of the data of groundwater points which drain long flow paths. By means of this approach, the groundwater framework was defined and the presence of a significant and continuous groundwater body within the sandstone complex was verified. A preliminary conceptual hydrogeological model was also proposed.