This paper presents a very effective interference technique for the sensing and researching of compressible fluid flow in a wind tunnel facility. The developed technique is very sensitive and accurate, yet easy to use under conditions typical for aerodynamic labs, and will be used for the nonintrusive investigation of flutter in blade cascades. The interferometer employs a high-speed camera, fiber optics, and available “of-the-shelf” optics and optomechanics. The construction of the interferometer together with the fiber optics ensures the high compactness and portability of the system. Moreover, single-shot quantitative data processing based on introducing a spatial carrier frequency and Fourier analysis allows for almost real-time quantitative processing. As a validation case, the interferometric system was successfully applied in the research of supersonic compressible fluid discharge from a narrow channel in a wind tunnel. Density distributions were quantitatively analyzed with the spatial resolution of about $50 \mathsf{\mu }\mathrm{m}$. The results of the measurement revealed important features of the flow pattern. Moreover, the measurement results were compared with Computational Fluid Dynamics (CFD) simulations with a good agreement.

Focus of this paper is aerodynamic investigation of tie-boss stabilization devices for extremely long rotor blades. This investigation covered measurements on multiple blade cascades and computational fluid dynamics (CFD) simulation of the flow past these cascades. Conclusions were drawn from results of the measurements and CFD and from the knowledge of prior investigation of the used blade cascade. Main focus of this paper is to describe influence of a tie-boss stabilization device on flow field in interblade channel. Tie-boss with more massive shape proved to cause lesser losses, while tie-boss with a tailored trailing edge showed lesser influence on flow turning.

Recent trends in the electric energy market such as biomass, waste incineration or combined cycle power plants require innovative solutions in steam turbine design. Variable operating conditions cause significant changes in flow field surrounding the steam turbine last stage blades. Therefore, the enlargement of operating range for last stage blades presents new challenges in design of turbine cascades. Several turbine cascades were designed and analyzed by commercial and in-house software of CTU Prague. Selected profiles were experimentally validated in the high-speed wind tunnel for 2D cascade measurements of the Institute of Thermomechanics of the Czech Academy of Sciences which is equipped by an adjustable supersonic inlet nozzle, perforated inserts at side walls and adjustable perforated tailboard. Comparisons are presented of numerical results with optical and pneumatic measurements for a wide range of inlet and outlet Mach numbers for optimized hub and tip profile cascades.

Aerodynamic experimental measurements and numerical simulations carried out on a model of a high-pressure valve assembly used for a nozzle governing of a turbine with 135 MW output are described in this paper. Aim of the study is to investigate effects of control valve’s strainers on pressure losses and unsteadiness in the flow field thus its effect to undesirable flow fluctuations