Qing Xiao

Prof. Dr. Qing Xiao

Department of Naval Architecture, Ocean & Marine Engineering, University of Strathclyde, Glasgow G4 0LZ, UK
orcid

Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 April 2023 in Wind Energy Science
Verified
Journal Article
Open access
PDF file
RBRoger Bergua
Roger Bergua
Amy RobertsonAmy Robertson
Amy Robertson
JJJason Jonkman
Jason Jonkman
EBEmmanuel Branlard
Emmanuel Branlard
AFAlessandro Fontanella
Alessandro Fontanella
AGAkhilesh Goveas
Akhilesh Goveas
This paper provides a summary of the work done within Phase III of the Offshore Code Comparison Collaboration, Continued, with Correlation and unCertainty (OC6) project, under the International Energy Agency Wind Technology Collaboration Programme Task 30. This phase focused on validating the aerodynamic loading on a wind turbine rotor undergoing large motion caused by a floating support structure. Numerical models of the Technical University of Denmark 10 MW reference wind turbine were validated using measurement data from a 1:75 scale test performed during the UNsteady Aerodynamics for FLOating Wind (UNAFLOW) project and a follow-on experimental campaign, both performed at the Politecnico di Milano wind tunnel. Validation of the models was performed by comparing the loads for steady (fixed platform) and unsteady (harmonic motion of the platform) wind conditions. For the unsteady wind conditions, the platform was forced to oscillate in the surge and pitch directions under several frequencies and amplitudes. These oscillations result in a wind variation that impacts the rotor loads (e.g., thrust and torque). For the conditions studied in these tests, the system aerodynamic response was almost steady. Only a small hysteresis in airfoil performance undergoing angle of attack variations in attached flow was observed. During the experiments, the rotor speed and blade pitch angle were held constant. However, in real wind turbine operating conditions, the surge and pitch variations would result in rotor speed variations and/or blade pitch actuations, depending on the wind turbine controller region that the system is operating. Additional simulations with these control parameters were conducted to verify the fidelity of different models. Participant results showed, in general, a good agreement with the experimental measurements and the need to account for dynamic inflow when there are changes in the flow conditions due to the rotor speed variations or blade pitch actuations in response to surge and pitch motion. Numerical models not accounting for dynamic inflow effects predicted rotor loads that were 9 % lower in amplitude during rotor speed variations and 18 % higher in amplitude during blade pitch actuations.

5 September 2018 in Wind Energy
Verified
Journal Article
Closed access
PDF file
Yuanchuan LiuYuanchuan Liu
Yuanchuan Liu
Qing XiaoQing Xiao
Qing Xiao
AIAtilla Incecik
Atilla Incecik
CPChristophe Peyrard
Christophe Peyrard

1 January 2022 in Renewable Energy
Verified
Journal Article
Closed access
YZYang Zhou
Yang Zhou
Qing XiaoQing Xiao
Qing Xiao
Yuanchuan LiuYuanchuan Liu
Yuanchuan Liu
AIAtilla Incecik
Atilla Incecik
CPChristophe Peyrard
Christophe Peyrard
SLSunwei Li
Sunwei Li

9 September 2019 in Energies
Verified
Journal Article
Open access
PDF file
YZYang Zhou
Yang Zhou
Qing XiaoQing Xiao
Qing Xiao
Yuanchuan LiuYuanchuan Liu
Yuanchuan Liu
AIAtilla Incecik
Atilla Incecik
CPChristophe Peyrard
Christophe Peyrard
Guang PanGuang Pan
Guang Pan
In this paper, we present numerical modelling for the investigation of dynamic responses of a floating offshore wind turbine subject to focused waves. The modelling was carried out using a Computational Fluid Dynamics (CFD) tool. We started with the generation of a focused wave in a numerical wave tank based on a first-order irregular wave theory, then validated the developed numerical method for wave-structure interaction via a study of floating production storage and offloading (FPSO) to focused wave. Subsequently, we investigated the wave-/wind-structure interaction of a fixed semi-submersible platform, a floating semi-submersible platform and a parked National Renewable Energy Laboratory (NREL) 5 MW floating offshore wind turbine. To understand the nonlinear effect, which usually occurs under severe sea states, we carried out a systematic study of the motion responses, hydrodynamic and mooring tension loads of floating offshore wind turbine (FOWT) over a range of wave steepness, and compared the results obtained from two potential flow theory tools with each other, i.e., Électricité de France (EDF) in-house code and NREL Fatigue, Aerodynamics, Structures, and Turbulence (FAST). We found that the nonlinearity of the hydrodynamic loading and motion responses increase with wave steepness, revealed by higher-order frequency response, leading to the appearance of discrepancies among different tools.

1 November 2021 in Ocean Engineering
Verified
Journal Article
Closed access
YZYang Zhou
Yang Zhou
Qing XiaoQing Xiao
Qing Xiao
CPChristophe Peyrard
Christophe Peyrard
GPGuang Pan
Guang Pan

4 November 2020 in Bioinspiration & Biomimetics
Verified
Journal Article
Open access
Yang LuoYang Luo
Yang Luo
Qing XiaoQing Xiao
Qing Xiao
GSGuangyu Shi
Guangyu Shi
GPGuang Pan
Guang Pan
DCDaoyi Chen
Daoyi Chen
The work in this paper focuses on the examination of the effect of variable stiffness distributions on the kinematics and propulsion performance of a tuna-like swimmer. This is performed with the use of a recently developed fully coupled fluid-structure interaction solver. The two different scenarios considered in the present study are the stiffness varied along the fish body and the caudal fin, respectively. Our results show that it is feasible to replicate the similar kinematics and propulsive capability to that of the real fish via purely passive structural deformations. In addition, propulsion performance improvement is mainly dependent on the better orientation of the force near the posterior part of swimmers towards the thrust direction. Specifically, when a variable body stiffness scenario is considered, the bionic body stiffness profile results in better performance in most cases studied herein compared with a uniform stiffness commonly investigated in previous studies. Given the second scenario, where the stiffness is varied only in the spanwise direction of the tail, similar tail kinematics to that of the live scombrid fish only occurs in association with the heterocercal flexural rigidity profile. The resulting asymmetric tail conformation also yields performance improvement at intermediate stiffness in comparison to the cupping and uniform stiffness.