The effect of yttrium (Y) on the critical resolved shear stresses (CRSS) of < a > basal slip, tension twinning and < c + a > pyramidal slip has been studied using micro-pillar compression tests along selected orientations at room temperature, on two magnesium (Mg) alloys with different Y contents (0.4 and 4 wt.%). The CRSS of < a > basal slip increased slightly from 30 ± 1 MPa (for Mg-0.4Y) to 37 ± 3 MPa (for Mg-4Y). In Mg-0.4Y, the resolved shear stress to activate the tension twin was determined to be 45 ± 12 MPa, while in Mg-4Y it was 113 MPa. The compressed samples were studied using scanning electron microscopy (SEM), transmission Kikuchi diffraction (TKD) and transmission electron microscopy (TEM). It was found that < c + a > dislocations slip mainly on (Pyra II) planes with a CRSS of about 119 MPa in Mg-0.4Y and slip mainly on (Pyra I) planes in Mg-4Y with a CRSS of 106 MPa. There is a significantly lowered CRSS ratio between < c + a > slip and < a > basal slip in both alloys (2.8 and 4.8) compared with that reported in bulk pure Mg (∼100). The easy activation of < c + a > on Pyramidal I slip is expected to promote the frequent cross-slip in Mg-4Y alloy.
5 April 2023 in Journal of Materials Science & Technology
The appearance of thin film metallic glasses (TFMGs) is gaining increasing interest because of their unique mechanical and anticorrosion properties and potential engineering applications. In this study, Cu–Zr–Al ternary thin film metallic glasses were fabricated by using DC magnetron sputtering equipment with various target powers. The evolution of the structure was systematically investigated by grazing incidence X-ray diffractometer, scanning electron microscopy, and transmission electron microscopy. The deposition rate increases with the increasing of applied target power. The as-deposited thin films show an amorphous structure. The compositional fluctuations on the nanometer scale indicate the presence of two Cu- and Zr-rich amorphous phases. The electrochemical corrosion measurements indicated that Cu–Zr–Al thin film metallic glasses had good corrosion resistance in the sulfuric acid solution. Nanoindentation results showed that the mechanical deformation was found to be homogenous and reproducible with a high value range for the hardness and modulus.
10 January 2022 in Materials Science and Engineering: A