UNS S32707 hyper-duplex stainless steel (HDSS) parts with complex shapes for ocean engineering were prepared by selective laser melting (SLM) process. In the process of SLM, the balance between austenite and ferrite was undermined due to the high melting temperature and rapid cooling rate, resulting in poor ductility and toughness. The solution annealing was carried out with various temperatures (1050–1200 °C) for one hour at a time. The evolution of microstructures, mechanical properties, and corrosion resistance of UNS S32707 samples prepared by SLM was comprehensively investigated. The results indicate that a decrease in nitrogen content during the SLM process reduced the content of austenite, and a nearly balanced microstructure was obtained after appropriate solution annealing. The ratio between ferrite and austenite was approximately 59.5:40.5. The samples with solution treated at 1150 °C and 1100 °C exhibited better comprehensive mechanical properties and pitting resistance, respectively.
In this study, diamond-copper composites were prepared with ZrC/Zr-coated diamond powders by spark plasma sintering. The magnetron sputtering technique was employed to coat the diamond particles with a zirconium layer. After heat treatment, most of the zirconium reacted with the surface of diamond and was transformed into zirconium carbide. The remaining zirconium on the zirconium carbide surface formed the outer layer. Owing to the method used to produce the ZrC/Zr-coated diamond in this study, the maximum thermal conductivity (TC) of 609 W·m−1·K−1 was obtained for 60 vol. % diamond-copper composites and the corresponding coefficient of thermal expansion (CTE) reached as low as 6.75 × 10−6 K−1. The bending strength of 40 vol. % ZrC/Zr-coated diamond-copper composites reached 255.95 MPa. The thermal and mechanical properties of ZrC/Zr-coated diamond-copper composites were substantially superior to those of uncoated diamond particles. Excellent properties can be attributed to the strengthening of the interfacial combination and the decrease in the interfacial thermal resistance due to the improvement associated with the ZrC/Zr coating. Theoretical analysis was also proposed to compare the thermal conductivities and CTE of diamond-copper composites fabricated with these two kinds of diamond powders.
3 June 2016 in International Journal of Minerals, Metallurgy and Materials
Flake graphite-diamond/Cu–Cr–Zr composites with good two-dimensional thermophysical properties were prepared by vacuum hot-pressing technology. The influence and working mechanism of the hot-pressing temperature on the relative density and thermal conductivity of the composites were studied to obtain the optimum sintering process. The results showed that with a pressing pressure of 10 ∼ 20 MPa, the relative density and thermal conductivity of the composite materials increased as the sintering temperature increased from 950 to 1010°C. When the temperature rose to 1010 ∼ 1040°C, a near fully dense composite material was obtained and thermal conductivity reached maxima of 410 and 119 W/m K parallel and perpendicular to the graphite planes, respectively, both of which are close to the theoretical value. However, relative density and thermal conductivity drastically decreased as the temperature continued to increase beyond 1070°C. This is attributed to the combined effect of sintering temperature and wettability between the matrix and the reinforcements.