This study utilises the optimization method to ascertain the levelized cost of hydrogen and life cycle carbon emissions of four water electrolysis hydrogen production systems across 31 provinces and regions of China, and compares these with hydrogen production from coal, natural gas and industrial by-products. The findings indicate that the grid-connected water electrolysis hydrogen production system has low-carbon advantages only in certain provinces, and time-of-use electricity prices can improve its economic competitiveness. The off-grid water electrolysis hydrogen production system can achieve near-zero carbon emissions, although additional investment is required to configure larger capacities for electricity energy storage and hydrogen storage. Projections indicate that by 2045–2050, this system could emerge as the most cost-effective to hydrogen production, a milestone that could be advanced by 5–15 years through the implementation of specific carbon reduction incentives or production subsidies. Prior to this timeframe, hydrogen production through industry by-products emerges as a viable alternative for the development of hydrogen energy.

Hydrogen is a carbon-free energy source that can be obtained from various sources. The blending of hydrogen represents a transitional phase in the shift from natural gas systems to hydrogen-based systems. However, concerns about the safety implications of introducing hydrogen have led to extensive discussions. This paper utilizes Fluent 17.0 numerical simulation software to simulate the leakage of hydrogen-blended natural gas in a closed domestic kitchen and analyze the concentration distribution and its variation pattern after a leakage. An experimental platform is set up, and a mixture of nitrogen and helium gas is used as a substitute for hydrogen-blended natural gas for the simulations and experiments. The simulation results demonstrate that the leaked gas spreads and accumulates towards the top of the space, gradually filling the entire area as the leak persists. As the hydrogen content in the leaked gas increases, the dispersion capacity of the gas in the confined space also increases. Furthermore, as the flow rate of the leaked gas increases, the average concentration of the leaked gas rises, and the gas stratification in the confined kitchen diminishes. The concentration distribution observed in the experiments aligns with the simulation results. After establishing the feasibility conditions of the model, the dispersion of the hydrogen-blended natural gas in the kitchen is further simulated. The results suggest that blending hydrogen into the gas enhances the dispersion of the gas after a leak, leading to a wider distribution within the kitchen and an increased risk in the event of a leak. Additionally, this paper employs the CASD module of FLACS 11.0 software to construct a three-dimensional geometric model of the domestic kitchen for simulation studies on the explosion of hydrogen-blended natural gas in a confined space. By adjusting the hydrogen ratio in the combustible gases present in the space and examining the variations in hydrogen concentration and external conditions, such as opening or closing the door, the influence on parameters including the peak explosion pressure, explosion overpressure, explosion flame temperature, and explosion response time are examined. Furthermore, the extent of the explosion area is determined, and the effect of hydrogen on the blast is clarified.

This study numerically investigates liquid water dynamics in a novel hybrid sinusoidal flow channel of a proton exchange membrane fuel cell (PEMFC). The two-phase flow is examined using a three-dimensional, transient computational fluid dynamics (CFD) simulation employing the coupled level set and volume of fluid (VOF) method. Simulations for hybrid and non-hybrid sinusoidal flow channels, including a straight flow channel, are compared based on their water exhaust capacities and pressure drops. Additionally, the effects of inlet gas velocity, wall wettability, and droplet interaction in the flow channel on the dynamic behaviour of liquid water are investigated. Results reveal that the novel hybrid sinusoidal channel designs are consistent in terms of quicker water removal under varying hydrophilic wall conditions. Also, it is found that the liquid surface coverage, detachment, and removal rate depends on droplet proximity to the walls, inlet gas velocity, and wall contact angle. Also, the time a droplet makes contact with the side walls affect the discharge time. Additionally, there is an improvement in the gas velocity magnitude and vertical component velocity across the hybrid sinusoidal channel designs. Therefore, the unique geometric configuration of the proposed hybrid design makes it a viable substitute for water management in PEMFC applications.