Compared with straight tunnels, over-excavation occurs on the inner side of the curved section during shield construction of small radius curved tunnels, and the disturbance to the ground surface and mechanical properties of surrounding rock and segment are more severe. This paper establishes the numerical models of small radius curve tunnels and straight tunnels to study the characteristics of surface deformation caused by the shield excavation of small radius curved tunnels and the influence of shield construction parameters on ground settlement, surrounding rock deformation, and segment force. The maximum error between the numerical simulation results and the measured surface settlement curve is 7.3%, which is in good agreement. The results show that: (1) The maximum value of the surface settlement of the small radius curve tunnel appears inside the curve section, and with the decrease in the curve radius, the surface settlement increases, and the distance between the peak settlement point and the tunnel center is larger. (2) When the curve radius of the tunnel is smaller, the lateral displacement of the ground surface moves farther to the inner side, and the range of soil mass with lateral displacement in the inner side is also wider. (3) Increasing the heading face pressure and grouting pressure can reduce surface settlement, but the heading face pressure should not exceed 350 kPa, and the grouting pressure should not exceed 250 kPa. (4) When the curve radius is smaller, the deformation of surrounding rock and the segment stress is larger.

This paper establishes a three-dimensional symmetrical shield model to investigate the influence of a double-line shield tunnel undercrossing an existing foundation pit and of changed grouting pressure on the deformation and mechanical characteristics of both the foundation pit and the tunnel itself, and it proposes a method of symmetrical segmented pressure, in which different grouting pressure is applied in different sections of the tunnel. The monitoring data are used to verify the reliability of the model, and the maximum relative error is 5.44%. The numerical results show that the maximum subsidence of the retaining pile and anchor are 3.76 mm and 10.33 mm, respectively, and the maximum tensile stress of the anchor is increased by 32.4%. The subsidence shape of the foundation pit raft is an arch with four corners warping upward and the maximum subsidence difference is 3.17 mm. Uneven subsidence of the tunnel occurs along the longitudinal direction, and large and small subsidences are located at the outside and underpart of the foundation pit, respectively, and the maximum and minimum values are 11.15 mm and 2.13 mm, respectively, and the maximum subsidence difference is 9.02 mm. The deformation and mechanical characteristics of both the foundation pit and the tunnel are significantly decreased by appropriately increasing the grouting pressure, and it is recommended that the grouting pressure should not exceed 300 kPa. The proposed method of segmented pressure can reduce the differential subsidence by 47.2% and the maximum tensile stress by 27.2%, so it can significantly reduce the uneven subsidence of the tunnel and improve the tunnel stress condition. The research results can provide a theoretical basis for the safe construction of shield tunnels under the existing foundation pit.

A subway train-steel spring floating slab track-tunnel coupling dynamic model, considering short and middle-long wavelength random track irregularities, and longitudinal connection between adjacent slabs of steel spring floating slab track, was developed. And the influence of slab length on dynamic characteristics of the system under different track conditions and train speeds are theoretically studied. The calculated results show: (1) In general, the acceleration of each component of the coupled system decreases with the increase of slab length under the perfectly smooth track condition; (2) Slab length has different influence laws on acceleration of each component of subway train-steel spring floating slab track-tunnel coupled system under random irregularity of track condition. The lower the dominant frequency distribution of vibration acceleration is, the higher influence slab length has; (3) With the increase of slab length, the force of rail, fastener and steel spring also decreases significantly, which helps to lengthen the service life of these components; (4) With the increase of slab length, the longitudinal bending moment of slab increases sharply at first, then it begins to drop slightly. When slab length exceeds the distance between two bogies of a vehicle, the longitudinal bending moment of slab changes little; (5) Slab length has significant influence on the dynamic force and displacement of the coupled system when train speed is higher.