In recent years, thermoelectric (TE) technology has been emerging as a promising alternative and environmentally friendly technology for power generators or cooling devices due to the increasingly serious energy shortage and environmental pollution problems. However, although TE technology has been found for a long time and applied in many professional fields, its low energy conversion efficiency and high cost also hinder its wide application. Thus, it is still urgent to improve the thermoelectric modules. This work comprehensively reviews the status of strategies and approaches for enhancing the performance of thermoelectrics, including material development, structure and geometry improvement, the optimization of a thermal management system, and the thermal structure design. In particular, the influence of contact thermal resistance and the improved optimization methods are discussed. This work covers many fields related to the enhancement of thermoelectrics. It is found that the main challenge of TE technology remains the improvement of materials’ properties, the decrease in costs and commercialization. Therefore, a lot of research needs to be carried out to overcome this challenge and further improve the performance of TE modules. Finally, the future research direction of TE technology is discussed. These discussions provide some practical guidance for the improvement of thermoelectric performance and the promotion of thermoelectric applications.

Found in some specific scenarios, drinking water is hard for people to get, such as during expeditions and scientific investigations. First, a novel water generator with only two thermoelectric coolers (Model A) is designed for extracting water from atmospheric vapor and then experimentally studied under a small inlet air flow rate. The impact of operating conditions on surface temperatures of cold/hot sides and water yield are investigated, including the air flow rate and humidity. Alternately, to determine the super performance of Model A, a comparative experiment between Model A and a reference model (Model B) is carried out. The results suggest that both the cold/hot temperature and water yield in Model A increases with the humidity and air flow rate rising. Seen in comparisons of Model A and Model B, it is found that, at an air humidity of 90% and air flow rate of 30 m³/h, the total water yield was increased by 43.4% and the corresponding value reached the maximum increment of 66.7% at an air humidity of 60% and air flow rate of 30 m³/h. These features demonstrate the advantage of Model A especially in low air humidity compared to Model B.